Ariens 936036 - 2548 Specifications download pdf (Page 10)

GB - 10

Battery voltage is lower than 12V. Refer to

Maintenance.

Oil pressure is low. Check oil and add if

necessary. See Engine Manual.

PTO is engaged. Disengage PTO before

starting tractor.

Safe condition to start.

FILLING FUEL TANK

To add fuel to fuel tank:

1. ALWAYS place unit in open or well ventilated area.

2. Stop engine and allow to cool.

3. Clean fuel cap and surrounding area to prevent dirt

from entering fuel tank.

4. Remove cap.

IMPORTANT: See engine manual for correct type and

grade of fuel.

5. Fill fuel tank to within 1/2 in. (1,2 cm) below bottom

of ﬁller neck.

6. Replace fuel cap and tighten.

7. ALWAYS clean up any spilled fuel.

PRESTART

Before starting:

1. Check engine oil and ﬁll if necessary. See engine

manual.

2. Check fuel and ﬁll if necessary.

3. Check safety interlock system. See Controls and

Features.

4. Adjust seat if needed.

STARTING

1. Sit in the operator’s seat.

2. Place the PTO knob in the off position.

3. Apply choke for a cold engine, place at 1/3 throttle

for a warm engine.

4. Press down brake pedal.

5. Turn the ignition key clockwise to the start position

until engine starts. Release key into run position.

IMPORTANT: DO NOT operate starter more than 15

seconds per minute. Damage can occur.

6. After engine starts, set throttle to fast position.

7. Release brake pedal.

8. Allow engine to warm up before applying load.

IMPORTANT: Run engine at 1/2 throttle for at least ﬁve

minutes prior to applying load in freezing temperatures.

TO OPERATE MOWER

1. With unit shut off, adjust deck to desired height of

cut.

2. Start engine.

3. Move throttle lever to about half speed.

4. Engage PTO.

5. Move the throttle lever forward to full engine speed.

6. Use forward and reverse pedals to move and use

steering wheel to change direction.

7. To stop mower, disengage PTO.

SHUT-OFF

Emergency Shut-Off

To shut-off unit in an emergency, turn ignition key to the

off position.

Normal Shut-Off

1. Turn off cruise control.

2. Stop unit.

3. Disengage PTO.

4. Lower attachment and engage parking brake.

5. Lower engine speed to slow position. Let engine

run a few minutes so engine parts cool evenly

before shutting engine off.

6. Turn ignition key to off position and remove key.

PARKING

Stop engine and engage parking brake to park. Remove

ignition key to prevent unauthorized use.

FOR BEST PERFORMANCE:

Cut grass when it is dry.

Keep mower blades sharp.

Keep mower deck properly leveled.

Adjust anti-scalp rollers to prevent scalping.

Do not set height of cut too low. For very tall grass, mow

twice.

Do not travel too fast.

Mow with the engine set at full throttle.

When mulching, only remove 1/3 of grass length per

cutting.

Discharge clippings into areas already cut.

Vary cutting pattern with each mowing.

Do not allow grass or debris to collect inside of mower

deck. Clean after each use.

WARNING: AVOID INJURY. Read and

understand the entire Safety section before

proceeding.

BATTERY

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comments to this Manuals

No comments

Ariens 936036 - 2548 Specifications Page 10

Comments to this Manuals

Related products and manuals for Garden tools Ariens 936036 - 2548