Ariens SNO-THRO 008-SS322E User Manual download pdf (Page 16)

Discharge Chute Deflector

ALWAYS position Discharge Chute Defiector in safe

direction and angie before starting engine. Use Handle

at rear of Defiector to position Defiector at desired

height. DO NOT throw snow any higher than necessary.

IMPORTANT: If Chute Deflector does not stay in set

position, adjust as directed in Maintenance Section, or

repair before operating equipment.

Discharge Chute

Discharge Chute rotates 220°. Rotate Chute with

Deflector Chute Handle or crank chute with Defiector

Chute Handie ON Models 938007,009 only. (Figure 10)

IMPORTANT: DO NOT force frozen Chute controls.

Start engine and run for 3-5 minutes to thaw. If still

frozen, take to warm place until controls are free.

Starting and Shut Off

Starting

1. Turn discharge chute straight ahead.

2. Push Primer Bulb 2 or 3 times for cold engine.

NOTE: When temperature is below -15° F additional

priming may be needed.

3. Pull choke control out to "Choke" position (Figure 7).

NOTE: A warm engine requires less choking than a cold

engine.

4. Insert Key into Ignition Switch.

5. Turn key to run position.

6. Grasp starter handle and pull rope out slowly until it

pulls harder, this is compression stroke, let rope

rewind slowly (Figure 8).

7. Pull rope with a rapid continuous full arm stroke. Let

rope rewind slowly.

IMPORTANT: DO NOT let Starter Handle snap against

Starter Handle Bracket.

8. Repeat until engine starts. (If engine does not start,

refer to Engine Manual.)

9. When engine has started, open Choke slowly by

gradually pushing Choke Control in.

Shut Off

1. Run Impeller a few minutes after use to prevent

freeze-up of Impeller.

2. Release Impeller Clutch Bail and allow Impeller to

stop.

3. Turn Ignition Switch to "Off" position.

4 Remove key.

Pre-Start

IMPORTANT: Before engine start check Impeller to be

sure it is not frozen. With key in "Stop" position,

squeeze Impeller Clutch Bail to Engaged position and

pull Recoil Starter Handle. If Impeller is frozen, (cannot

pull Starter Handle) move unit to a heated area and thaw

to prevent possible damage.

Ariens® Sno-Thro® Orig. 4/96

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Ariens SNO-THRO 008-SS322E User Manual Page 16

Comments to this Manuals

Related products and manuals for Cars Ariens SNO-THRO 008-SS322E