Ariens SNO-THRO 008-SS322E User Manual download pdf (Page 12)

Discharge Chute Crank (938006,009)

To install Discharge Chute Crank (Figure 6);

9. Remove Nut from bolt that holds Recoil Starter

Handle Bracket in place.

10. Pull the Chute Crank Assembly up so hole in

Chute Crank Bracket fits behind/under Lower

Handle Bar and over bolt end.

NOTE: DO NOT pull Chute Crank Assembly up too far.

If Chute Crank Bracket goes past Lower Handle Bar,

48T Gear and Spacer will fall off into unit.

11. With Crank Knob straight up and Discharge Chute

straight forward, check that 48T Gear meshes with

12T Pinion at Space and Tooth Identification

Marks. Align if necessary.

6. Remove Rear Cap Screw and Nut from rear of

Discharge Chute (Figure 5).

7. Tip Discharge Chute up and install hardware just

removed.

8. Tighten hardware at rear of Discharge Chute first,

then at sides.

Nut

Recoil Starter Handle Bracket

Chute Crank Shaft

Crank Knob

Chute Crank Bracket

Lower Handle Bar

Space & Tooth Identification Marks

Spacer

48T Gear

10. 12T Pinion

11. Cotter Pin

Figure 6

Ariens» Sno-Thro» Orig. 4/96

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

No comments

Ariens SNO-THRO 008-SS322E User Manual Page 12