Ariens 991065-Max Zoom 2552 Specifications download pdf (Page 15)

GB - 15

FOR BEST PERFORMANCE

Cut grass when it is dry.

Keep mower blades sharp.

Keep mower deck properly levelled.

Adjust anti-scalp rollers to prevent scalping.

Do not set height of cut too low. For very tall

grass, mow twice.

Do not travel too fast.

Mow with the engine set at full throttle.

When mulching, only remove 1/3 of grass

length per cutting. Do not cut more than 1

inch (2.54 cm) at any one time.

Discharge clippings into areas already cut.

Vary cutting pattern with each mowing.

Do not allow grass or debris to collect inside

of mower deck. Clean after each use.

Proper maintenance can prolong the life of

unit. The following charts show the

recommended service schedule. More

frequent service may be required due to

working conditions (heavy loads, high

ambient temperatures, dusty conditions, or

airborne debris).

See the maintenance instructions in the

Engine Manual for additional information.

MAINTENANCE SCHEDULE

WARNING: AVOID INJURY.

Read and understand entire

Safety section before proceeding.

Period Service Task

Each

Use

Check Safety Interlock WARNING: Safety interlock system

failure and improper operation of unit can

result in death or serious injury. Test this

system each time the unit is operated. If

this system does not function as

described, do not operate until repairs are

made. See Safety Interlock System on

page 11.

Check Parking Brake

Interlock System

See Parking Brake Interlock System on page 11.

Check Hydraulic Fluid Check hydraulic oil level mark on cap/dipstick. Add

20W50 engine oil as needed. Do not overfill. See

Check Hydraulic Fluid Level on page 17.

Check Tires See Specifications on page 29for correct tire

pressure.

CAUTION: Avoid injury! Explosive

separation of tire and rim parts is possible

when they are serviced incorrectly:

•Do not attempt to mount a tire without the

proper equipment and experience to

perform the job.

• Do not inflate the tires above the

recommended pressure.

• Do not weld or heat a wheel and tire

assembly. Heat can cause an increase in air

pressure resulting in an explosion. Welding

can structurally weaken or deform the

wheel.

• Do not stand in front or over the tire

assembly when inflating. Use a clip-on

chuck and extension hose long enough to

allow you to stand to one side.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Comments to this Manuals

No comments

Ariens 991065-Max Zoom 2552 Specifications Page 15

Comments to this Manuals

Related products and manuals for Utility Vehicle Ariens 991065-Max Zoom 2552