Ariens Pro 21 Specifications download pdf (Page 20)

GB - 20

To install the drive belt:

IMPORTANT: Be sure the belt seats in idler

and pulley grooves with the idler touching the

back (flat) side of belt.

1. Install the new belt on the transmission

input pulley and idlers, route it through

the belt channel, and then install the belt

on the engine pulley. See Figure 15 and

Figure 16.

NOTE: Make the sure the belt is inside the

two belt fingers near the engine pulley.

2. Position the bent belt finger so it lightly

contacts the belt, and then tighten it in

position.

3. Connect the wheel drive cable spring to

the idler arm as shown in Figure 15, and

then connect the wheel drive cable to

the transmission mount. See Figure 17.

4. Connect the idler return spring to the

idler arm.

5. Install the wave washer and blade

adapter on the crankshaft.

6. Install the center baffle on the mower

deck.

7. Install the blade on the blade adapter.

Make sure the blade hardware is

tightened to the proper torque. See To

install blade: on page 16.

8. Replace the transmission cover.

9. Connect spark plug wire to the spark

plug.

Figure 16

1. Drive Belt

2. Engine Pulley

3. Bent Belt Finger

4. Belt Channel

4

3

2

1

Figure 17

Note belt routing around

idlers and belt fingers.

Push belt through belt

channel and install it

on the engine pulley.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments