Ariens 991065-Max Zoom 2552 Specifications download pdf (Page 10)

WARNING:AVOIDINJURY.

Readandunderstandentire

Safety section before proceeding.

UNIT ASSEMBLY

Package Contents:

Unit, Mower Deck and Literature Pack

Preparation Checklist

Refer to the Owner/Operator manual as

required.

1. Unpack Unit - Remove shrink wrap and

packaging materials.

2. Remove Unit From Container - Open

Bypass Valves (dump valves) (See

Moving the Unff with the Engine Off on

page 15).

Push unit from container onto a level

surface. Close the bypass valves.

3. Tires - See Specifications on page 31.

CAUTION: Avoid injury! Explosive

separation of tire and rim parts is

possible when they are serviced

incorrectly:

Do not attempt to mount a

tire without the proper

equipment and experience

to perform the job.

Do not inflate the tires

above the recommended

pressure.

Do not weld or heat a wheel

and tire assembly. Heat can

cause an increase in air

pressure resulting in an

explosion. Welding can

structurally weaken or

deform the wheel.

Do not stand in front or over

the tire assembly when

inflating. Use a clip-on

chuck and extension hose

long enough to allow you to

stand to one side.

4. Seat - See Seat Adjustments on

page 13 and Service Position on

page 18.

5. Position Steering Levers - Remove

eccentric spacers and rotate steering

levers to the operating position. Reinstall

spacers. Tighten hardware securely.

See Aligning the Steering Levers

(Figure 14) on page 24.

1 2 1

3

1. Steering

Levers

2. Seat

Figure 3

3. Mounting

Hardware

OF314I

6. Battery - Remove battery from unit and

charge (See Battery on page 22).

7. Check Engine Crankcase - Check and

add oil if needed. See Engine Manual for

specifications.

8. Fill Engine Fuel Tank - Add clean fuel to

the fuel tank.

NOTE: See engine manual for fuel type.

9. Hardware - Check for loose hardware.

10. Check Safety Interlock System - Check

to see that the interlock system operates

correctly (See Safety Interlock System

on page 12).

A

WARNING: FAILURE OF

INTERLOCK together with

improper operation can result in

severe personal injury.

11. Lubrication - Lubricate all fittings per

maintenance label under seat and check

hydrostat oil level (See Lubricate Unit on

page 23).

12. On 60-inch Decks: Remove the

discharge chute from the transport

position and place the discharge chute

in the operating position.

13. Level Deck - Check unit to ensure deck

level set at factory has been maintained

(See Leveling the Mower Deck on

page 28).

14. Check Function of all Controls - Ensure

unit runs and performs properly.

WARNING: FAILURE OF

,_ CONTROLS could result in death

or serious injury.

GB - 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 107 108

Comments to this Manuals

No comments