Ariens 90203200 Owner's Manual download pdf (Page 7)

The operation of any tiller can result in foreign objects thrown into the eyes, which can result

in severe eye damage. Always wear safety glasses or eye shields before starting your tiller

and while tilling. We recommend a wide vision safety mask for over spectacles or standard

safety glasses.

TILLING

The speed and depth of tilling is regulated by the position

of the depth stake and wheel height.

The depth stake should always be below the wheels for

digging. It serves as a brake to slow the tiller’s forward

motion to enable the tines to penetrate the ground. Also,

the more the depth stake is lowered into the ground the

deeper the tines will dig.

DEPTH STAKE (See Fig. 6)

Adjust depth stake by removing the hairpin clip and clevis

pin. Change depth stake to desired position. Replace the

clevis pin and hairpin clip.

• For normal tilling, set depth stake at the second or third

hole from the top.

WHEELS (See Fig. 6)

Adjust wheels by removing the hairpin clip and clevis pin.

Change wheel position. Replace the hairpin clip and clevis

pin.

• For normal tilling, set wheels at the second or third

hole from the top.

depth_stake_4

DEPTH

STAKE

SPRING

HAIRPIN CLIP

AND CLEVIS PIN

WHEEL

Fig. 6

OPERATION

HOW TO USE YOUR TILLER

Know how to operate all controls before adding fuel and

oil or attempting to start engine.

STOPPING (See Fig. 5)

TINES

1. Release tine control to stop move ment.

ENGINE

2. Set the speed control lever at the low speed position

and allow the engine to run at low speed for 1 or 2

minutes before stopping.

3. Turn the ENGINE SWITCH counterclockwise to the

position “ O ” (OFF).

4. Close the fuel valve.

5. Pull the starter handle slowly and return the handle to its

original position when resistance is felt. This operation

is necessary to prevent outside moist air from intruding

into the combustion chamber.

NOTE: Never use choke to stop engine.

IMPORTANT: TO STOP ENGINE IN AN EMERGENCY, TURN

THE ENGINE SWITCH TO THE OFF POSITION.

TINE OPERATION (See Fig. 5)

• Squeeze tine control to handle.

Fig. 5

TINE CONTROL

“OFF” (UP) PO SI TION

TINE CONTROL

“ON” (DOWN) PO SI TION

THROTTLE

CONTROL

ENGINE

SWITCH

FUEL VALVE

RECOIL

STARTER

THROTTLE

CONTROL

ENGINE

SWITCH

FUEL

VALVE

1 2 3 4 5 6 7 8 9 10 11 12 ... 63 64

Comments to this Manuals

No comments

Ariens 90203200 Owner's Manual Page 7

Comments to this Manuals

Related products and manuals for Grass trimmers Ariens 90203200