Ariens 009-1648 User Manual download pdf (Page 15)

Neutral Lock Position

Figure 4

Power Take Off (PTO) Switch

The Power Take Off Switch is used to engage and

disengage the attachment.

---------

When the PTO Switch is pulled out, it is in

the “ON” position and the attachment is

^ engaged.

When the PTO Switch is pushed in, it is in

^ the “OFF” position and the attachment is

disengaged.

Attachment Lift Lever

To raise the attachment, move the lever to

iWl'Ih the right to unlock It and pull up on lever.

I|||X To lower the attachment, move the lever to

the right to unlock It and push lever down.

Maximum cutting height is 5"; lowest cutting height is

1.38". Intermediate positions allow selection of cutting

heights between these values.

Safety interiock System

The engine must shut off if the operator leaves the seat

while the Travel-Speed Control Levers are In any

position other than the “NEUTRAL LOCK” position and

the PTO Switch is in the “ON” position.

Transmission Dump Vaives

Closing the Dump Valves allows the unit to by pushed

by hand. Dump Valves must be open to drive unit.

IMPORTANT: NEVER push or pull (tow) the unit with

another vehicle. Use a truck or trailer when transporting

or transmission damage can occur.

To Open the Dump Valves: Lift up on the Dump Valve

Rod and pull rearward until the expanded section of the

rod comes through the hole in the trailer hitch. Push the

rod back down to lock it into position (Figure 5).

To Close the Dump Valves: Lift up on the Dump Valve

Rod and push it back fon/vard.

1. Dump Valve Rod

2. Trailer Hitch

Figure 5

Pre-Start

Check Tires

Before each use, make a visual check of tires.

Check Engine Oil

Check that the engine oil is at proper level using

dipstick. Fill or change per instructions in General

Maintenance.

Check Seat Adjustment

Be sure all controls can be reached safely from

operator’s position. If seat needs adjustment, refer to

Adjustments.

Test Operation of All Controls

A CAUTION

Check function of all controls before starting engine.

All safety devices and guards must be in position

and operating properly or injury may result.

Ariens* EZRider'“ Orig. 1/98

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Comments to this Manuals

No comments

Ariens 009-1648 User Manual Page 15

Comments to this Manuals

Related products and manuals for Gardening equipment Ariens 009-1648