Ariens Sno-Thro 924117 - 1024 User Manual download pdf (Page 19)

GB - 19

TRANSPORT

ALWAYS shut off engine, remove key and

drain fuel when transporting unit on a truck or

trailer.

Use extra care when loading or unloading unit

onto trailer or truck.

Secure unit chassis to transport vehicle.

NEVER secure from rods or linkages that

could be damaged.

DO NOT transport machine while engine is

running.

Ariens Dealers will provide any service or

adjustments which may be required to keep

your unit operating at peak efﬁciency. Should

engine service be required, contact an Ariens

dealer or an authorized engine manufacturer's

service center.

SERVICE POSITION

Place unit on a ﬂat level surface. Tip unit

forward onto front of impeller housing for

service. Assure unit is secure and will not tip

over. Strap and clamp onto bench if needed.

MAINTENANCE SCHEDULE

The chart below shows the recommended

maintenance schedule that should be

performed on a regular basis. More frequent

service may be required.

* After ﬁrst two hours of operation.

CHECK DUAL HANDLE

INTERLOCK

Without the engine running, press down

(engage) both clutch levers. Release

attachment clutch lever. Attachment clutch

should remain engaged until traction clutch

lever is released, then both clutches must

disengage.

CHECK FASTENERS

Make sure all hardware is tightened properly.

MAINTENANCE

WARNING: AVOID INJURY. Read

and understand Maintenance and

Service and Battery Safety Rules in

Safety section before attempting any

maintenance.

WARNING: Before tipping unit up

onto housing, remove fuel so no

spills will occur and remove battery

(if equipped). Ensure unit is secure

and will not tip over during

maintenance.

MAINTENANCE SCHEDULE

Service

Performed

Each

Use

Every

5 hrs.

Every

25

hrs.

Yearly

Check Dual

Handle

Interlock

•

Check

Fasteners

•

Check

Clutches

•

Clean Engine •

Check Engine

Oil

•

Change

Engine Oil

*

•

Check Tire

Pressure

•

Check Auger

Gearcase

••

General

Lubrication

••

Battery

Maintenance

••

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 32 33

Comments to this Manuals

No comments