Ariens Sno-Thro 924117 - 1024 User Manual download pdf (Page 27)

GB - 27

7. Reconnect chute crank and secure with

spring clip. If equipped, reconnect remote

cap deﬂector cable and/or electric chute

wire harness.

8. Replace belt cover.

TRACTION DRIVE BELT

REPLACEMENT

NOTE:

Housing and frame must be tipped

apart and attachment drive belt removed from

engine sheave in order to change traction

drive belt.

1. Remove attachment drive belt (see

Attachment Drive Belt Replacement

).

2. Pull idler away from traction drive belt and

remove belt from idler pulley, engine

sheave and driven pulley (it may be

necessary to turn engine pulley using

recoil handle).

NOTE:

To gain clearance, engage traction

clutch and if necessary pull back attachment

idler arm clevis pin.

3. Install new traction drive belt onto

attachment pulley and engine sheaves.

4. Replace attachment drive belt (See

Replace

Attachment Drive Belt

)

.

FRICTION DISC REPLACEMENT

1. Place unit into service position.

2. Remove bottom cover by removing four

cap screws.

3. Place speed selector in ﬁrst (1) position

and depress traction clutch lever to hold

friction disc and hub in position.

4. Remove cap screws from hub

(Figure 21).

5. Release traction clutch lever, shift to third

(3) position, and remove friction disc.

6. Secure new friction disc on hub with ﬁve

cap screws and torque cap screws to

8-10 lbf-ft (10,6-13,3 N•m).

7. Replace bottom cover.

8. Adjust traction drive clutch (see

Traction

Drive Clutch Adjustment

).

BATTERY (924300, 505, 506, 508)

Charging

1. Place unit on a level surface and shut off

engine.

2. Disconnect negative (-) cable ﬁrst, then

positive (+) cable.

3. Loosen wing nut and remove battery.

Place battery on bench or other well

ventilated place.

4. Connect positive (+) lead of charger to

positive (+) terminal, and negative (-) lead

to negative (-) terminal.

5. Charge the battery at two and a half amps

for ten hours.

6. Reinstall battery into unit and connect

positive (+) cable ﬁrst, then negative (-)

cable.

Replacing

Use U1R or U1L; 340 to 350 CCA @ 0˚F type

batteries.

1

2

3

4

5

Figure 21

6

OS0612

1. Cap Screw

2. Cotter Pin

3. Friction Disc

4. Shift Arm

5. Chain

6. Idler Hex Shaft

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33

Comments to this Manuals

No comments