Ariens 936022 (Sierra 1340G) Service Manual download pdf (Page 24)

5 - 24

5.2 ENGINE REMOVAL

1. Open and remove the hood from the unit.

2. Remove the negative cable from the battery.

3. Remove the attachment from the unit.

4. Remove the PTO clutch from the bottom of the

engine sheave. Remove the main drive belt from

the engine sheave by setting the parking brake.

5. Remove the throttle and choke control from the

engine.

6. Remove the electrical wiring from the engine

(charge lead, oil pressure lead, fuel solenoid lead,

and magneto kill wire).

7. Remove the exhaust system from under the frame.

Separate the muffler from the exhaust pipe that is

bolted to the engine.

8. Remove the engine bolts and lift the engine with a

hoist to remove it from the frame.

5.3 ENGINE INSTALLATION

1. Check the engine base and unit frame for damage

before installing the engine.

2. Place the throttle, choke control, and electrical wire

out of the way prior to placing the engine onto the

unit frame.

3. Once the engine is bolted onto the frame install the

exhaust system and then tighten the mounting

hardware.

4. Install the engine sheave and belts. Connect PTO

clutch, electrical wiring, throttle and choke controls.

5. Prior to installing the attachment check for proper

belt alignment and clutch function.

6. Install the negative battery cable onto the battery.

7. Reinstall the attachment onto the unit.

8. Install and close the unit hood and test operation

and function of the engine.

Figure 24

9336-18

Figure 25

936-19

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 65 66

No comments

Ariens 936022 (Sierra 1340G) Service Manual Page 24