Ariens 936022 (Sierra 1340G) Service Manual download pdf (Page 20)

4 - 20

6. Adjust the ball joint to align with ball on the

transaxle shift arm. Attach the ball joint to the ball

on the shift arm.

4.16 ADJUSTMENT OF DIRECTIONAL

CONTROL PEDAL

Remove the clevis pin holding the shift rod to the

control pedal cross shaft. Push the forward pedal down

and mark the pedal arm. Depress the rear directional

control pedal and mark the pedal arm.

Place the pedal arm in the center of the forward and

reverse marks and adjust the clevis to allow the clevis

pin to be installed. Hold in place with the hardware

removed earlier.

4.17 ADJUSTING THE BRAKE (HYDRO)

The brake was set at the factory for a specific running

clearance. To check for proper setting, place a feeler

gage between two of the disks (the brake will need to

be released). There should be 0.015" to 0.025"

clearance.

If the clearance is not correct, make the necessary

adjustment with the brake lever tension nut.

The brake arm compression spring in the front of the

brake arm should be compressed to 0.75" with the

parking brake set.

4.18 ADJUSTING THE BRAKE (GEAR)

The brake was set at the factory for a specific running

clearance.

Raise and support the rear of the unit with the wheels

off the ground.

Tighten the brake adjustment nut and then back off the

nut until the rear wheel drag is eliminated.

Figure 15

936-11

Figure 16

936-12

Figure 17

OT0840

1. Disc Brake

2. Castellated Nut w/Cotter Pin

3. Compression Spring- .78" OD x 1 " long

4. Feeler Gage

5. Washer

6. Nylon Lock Nut

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 65 66

Comments to this Manuals

No comments

Ariens 936022 (Sierra 1340G) Service Manual Page 20

Comments to this Manuals

Related products and manuals for Snow throwers Ariens 936022 (Sierra 1340G)