Ariens 921017 - Deluxe 24 Platinum Specifications download pdf (Page 23)

EN - 23

SNOW REMOVAL

IMPORTANT: Allow unit and engine to adjust

to the outdoor temperature before clearing

snow.

NOTE: Attachment clutch should be engaged

before traction drive clutch when throwing

snow.

1. Select Speed Control position and

direction.

2. Engage Attachment Clutch – Right Hand

Lever.

3. Engage Traction Drive Clutch – Left

Hand Lever.

IMPORTANT: DO NOT overload unit capacity

by attempting to clear snow at too fast a rate.

Use slow speed to clear deep or hard packed

snow.

Tips for Operation

Snow is best removed as soon as possible

after snow fall.

To clear an area, run unit in an overlapping

series of paths. For large areas, start in the

middle and throw snow to each side, so snow

is not cleared more than once.

ALWAYS direct snow away from area to be

cleared and with direction of the wind.

TRAVELING

To travel from one work area to another:

1. Set Throttle to Slow or Part-Throttle

position.

2. 921013, 017, 018, 022, 027, 031, 034:

Press down on handlebars enough to

raise front of unit slightly off surface.

921023: Place the unit in the transport

position (see Track Angle on page 20).

3. Engage traction drive clutch lever

without engaging attachment drive

clutch.

TRANSPORT

ALWAYS shut off engine, remove key, and

close fuel shut-off valve when transporting

unit on a truck or trailer.

Use extra care when loading or unloading

unit onto trailer or truck.

Secure unit chassis to transport vehicle.

NEVER secure from rods or linkages that

could be damaged.

DO NOT transport machine while engine is

running.

Ariens Dealers will provide any service or

adjustments which may be required to keep

your unit operating at peak efficiency. Should

engine service be required, contact an Ariens

dealer or an authorized engine

manufacturer's service center.

SERVICE POSITION

(Figure 23)

1. Shut off engine, remove key, disconnect

spark plug wire and allow unit to cool

completely.

2. Close fuel shut-off valve (see Fuel Shut-

Off Valve on page 21).

3. Drain fuel tank and fuel system (see

Engine Manual for complete

instructions).

4. Place unit on a flat level surface. Tip unit

forward onto front of auger housing for

service.

IMPORTANT: Ensure unit is secure and will

not tip over. Strap and clamp onto bench if

needed.

MAINTENANCE

WARNING: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

WARNING: Before tipping unit up

onto housing, remove fuel so no

spills will occur. Ensure unit is

secure and will not tip over during

maintenance.

Figure 23

Service Position

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Comments to this Manuals

No comments