Ariens Zoom 1844 XL Specifications download pdf (Page 19)

GB-19

Installing the Mower Deck (Figure 18)

1. Slide mower deck under unit.

2. Connect mower mounting arms to deck with mower

mounting pins.

3. Install link chains on the mower lift arms in the same holes

they were removed from.

4. Install PTO mower belt (See Remove PTO Belt on

page 18).

5. Level mower deck (See Leveling the Mower Deck on

page 19).

Leveling the Mower Deck

These adjustments should be made on a level surface with the

tires inflated to the correct air pressure.

Level the mower with the slots where 4 chains fasten to the

mower mounting brackets (Figure 19).

1. Shut OFF engine. Engage parking brake. Remove the

ignition key.

2. Raise mower deck to its highest position and place 4-7/8 in.

(12.4 cm) tall blocks at each rear corner and 4-3/4 in.

(12 cm) tall blocks at each front corner.

3. Lower deck onto the blocks.

4. Loosen the locknuts on the side where the chains are slack

and slide the bolt down the slot until the chains are tight.

5. Tighten the locknuts.

6. Lift mower and remove blocks.

7. Measure height of deck at each side. Measurements must

be within 1/16 in. (1.59 mm) of each other.

8. If measurements are out of range, fix by adjusting chains

on low side of deck.

9. Once deck is level side to side, measure height of deck at

middle of front and on both sides of rear. Front of deck

should be 1/8 in. (3.18 mm) lower than rear.

Figure 18

1. Mower Lift Arm

2. Link Chain

3. Mower Mounting Arm

4. Mower Mounting Pin

5. Mower Lift Arms

Locked

OF3765

1. Chains

2. Lock Nuts and Slots

3. Mower Mounting

Brackets

4. 4-3/4 in. (12 cm)

Blocks

5. 4-7/8 in. (12.4cm)

Blocks

Figure 19

OF4050

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Ariens Zoom 1844 XL Specifications Page 19

Comments to this Manuals

Related products and manuals for Lawnmowers Ariens Zoom 1844 XL