Ariens Zoom 1844 XL Specifications download pdf (Page 13)

GB-13

Ariens Dealers will provide any service which may be required to

keep your unit operating at peak efficiency. Should engine service

be required, it can be obtained from a Ariens Dealer or the engine

manufacturer’s authorized service center.

SERVICE POSITION

1. Place unit on a flat level surface. ALWAYS stop engine.

Ensure unit is secure and will not tip over. Strap and clamp

onto lift if used.

2. Place steering levers in neutral and engage parking brake.

3. Remove wing knob.

4. Tip seat forward (Figure 6)

5. When service is complete, lower seat and secure with wing

knob or hex nut.

HYDRAULIC FLUID

Check Hydraulic Fluid Level

1. Start the unit and run it to operating temperature (about 10

minutes).

2. Cycle the control levers forward and backward two or three

times.

3. For units equipped with a hydraulic deck lift, raise and

lower the deck completely two or three times.

4. Shut OFF engine. Engage parking brake. Remove the

ignition key.

5. Put seat in service position. See Service Position on

page 13.

6. Remove any dirt that may be around the cap/dipstick on the

hydraulic reservoir.

7. Remove cap/dipstick.

8. Check hydraulic oil level mark on cap/dipstick.

9. Add 15W50 synthetic oil as needed. Do not overfill.

Change Hydraulic Fluid and Filter

Change the hydraulic oil filter and hydraulic oil every 500 hours.

Use Mobil 15W50 synthetic oil for best component life.

1. Clean around dipstick cap and dipstick. Remove dipstick.

2. Place container under oil filter to catch oil.

3. Remove oil filter.

4. Allow tank to drain.

5. Lubricate rubber gasket on new oil filter with clean

hydraulic oil.

6. Spin new oil filter onto filter housing until it makes contact.

Tighten oil filter another 1/2 turn.

7. Add new oil to the oil tank. It will take about 2.5 quarts

(2.4 L). Use Mobil 15W50 synthetic oil for best pump and

wheel motor life.

8. Properly dispose of waste oil.

SERVICE AND ADJUSTMENTS

WARNING: AVOID INJURY. Read and understand

entire Safety section before proceeding.

CAUTION: HOT SURFACES may result in injury. DO

NOT touch engine or drive parts which are hot from

operation. Allow parts to cool before servicing.

CAUTION: Be sure footing is secure to accomodate

weight shift of seat when rotating it into service position.

1. Service Position

2. Steering Levers

3. Parking Brake

4. Battery

Figure 6

OF3363

WARNING: HYDRAULIC FLUID can result in severe

burns. Fluid in hydraulic system can penetrate skin and

result in serious injury or death.

Be sure to stop the engine before doing any work on

hydraulic parts.

Keep body and hands away from pin holes or nozzles

which expel hydraulic fluid when under pressure. Use

paper or cardboard, not hands, to search for leaks.

Ensure all hydraulic fluid connections are tight and all

hydraulic hoses and lines are in good condition before

applying pressure to system.

FOREIGN FLUID INJECTED INTO BODY can result in

gangrene. Fluid must be surgically removed within a

few hours by a doctor familiar with this form of injury.

FULL Mark

Operating

Range

OE0380

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Comments to this Manuals

No comments

Ariens Zoom 1844 XL Specifications Page 13

Comments to this Manuals

Related products and manuals for Lawnmowers Ariens Zoom 1844 XL