Ariens 915502 - 1540 Specifications download pdf (Page 23)

GB - 23

• Internal Contact: Drink large quantities of

water. Follow with Milk of Magnesia,

beaten egg or vegetable oil. Get medical

attention immediately!

• In case of internal contact, DO NOT

induce vomiting!

IMPORTANT: DO NOT fast charge.

Charging at a higher rate will damage or

destroy battery.

IMPORTANT: ALWAYS follow information

provided on battery and battery charger.

Contact battery and battery charger

manufacturers’ for detailed instructions.

1. Remove battery from unit (see Battery

Removal and Installation on page 22).

2. Place battery in a well-ventilated area.

3. Connect positive (+) lead of charger to

positive (+) terminal, and negative (–)

lead of charger to negative (–) terminal.

4. Charge battery according to battery

charger and battery manufacturers’

instructions.

5. Install battery on unit (see Battery

Removal and Installation on page 22).

Jump Starting the Battery

(Figure 21)

IMPORTANT: The unit used for jump starting

should have a 12 volt battery with at least 500

cold cranking amperes, and a negatively

grounded system.

IMPORTANT: Ensure battery is not frozen. If

the battery is frozen, remove battery from unit

and allow battery to thaw before charging.

1. Connect positive (+) jumper cable to

positive (+) terminal of discharged

battery.

2. Connect the other end of positive (+)

jumper cable to positive (+) terminal of

booster battery.

3. Connect negative (–) jumper cable to

negative (–) terminal of booster battery.

4. Connect the other end of negative (–)

jumper cable to engine of unit with

discharged battery.

NOTE: If engine will not start, unit or battery

may need service.

5. Start engine.

6. After engine starts, leave jumper cables

connected for one to two minutes.

7. Disconnect jumper cables in reverse

order of installation.

8. Operate unit as normal to charge battery.

STEERING LEVER

ADJUSTMENTS

Adjusting Steering Levers to Match

(Figure 22)

NOTE: Each steering lever can be positioned

further forward or further backward.

1. Loosen mounting hardware.

2. Position steering levers to match.

3. Tighten mounting hardware.

Adjusting Height of Steering Levers

(Figure 22)

There is a low and a high position for steering

levers. Remove mounting hardware and

place steering levers in the low or high

position. Tighten mounting hardware.

WARNING: Make sure cables are

clear of any moving engine parts

before starting engine.

1

OE0046

Figure 22

2

1. Steering Levers

2. Mounting

Hardware

3. Low Position

4. High Position

5. Handlebar

Weldment

6. Seat Support

3

4

2

5

6

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Comments to this Manuals

No comments