Ariens 924 User Manual download pdf (Page 60)

Engine and Headlight

9.7 Add-On Alternator

Remove rewind starter keps nuts and starter from

engine. (Note location of rewind starter handle).

Remove pushout plug from top center of rewind

starter.

On die cast recoils, remove center hole cast material

with 1/4 inch drill.

Rotate pulley to expose 3 punch-outs (Figure 1),

place starter on back-up surface and remove punch-

outs with 1/8" punch.

NOTE: Remove quadrant mounting hardware (on

Models 932001, 4, 6 and 7) for additional clearance

when mounting alternator. Secure quadrant when

assembled.

For Use On Sno-Thro Models

Model

924050

924051

924074

924075

Serial No.

050501 & Up

000501 & Up

000101 & Up

Install alternator shaft over crank shaft nut (tap hex

with pipe or light drift until it contacts flywheel

washer) and place centering tube onto alternator

shaft.

NOTE: 3" alternator shaft and short centering tube

are for 932000 Series and ST 524. 4" alternator

shaft and long centering tube are for ST 824. Alter

nator shaft must extend approximately 5/8" beyond

top of starter, if not, incorrect shaft has been in

stalled.

Center rewind starter (using centering tube) and

secure with keps nuts removed earlier.

Remove centering tube and position alternator on

to alternator shaft with lighting connector receptical

to right (as viewed from operator's position).

Secure alternator to rewind starter with 3 self

tapping screws.

IMPORTANT: DO NOT exceed 15 inch pounds

seating torque (after threads are formed) to prevent

screws from contacting pulley or distorting alter

nator.

9-4

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 71 72

Comments to this Manuals

No comments

Ariens 924 User Manual Page 60

Comments to this Manuals

Related products and manuals for Gardening equipment Ariens 924