Ariens Sno-Thro 926 Series Specifications download pdf (Page 35)

EN - 35

9. Install pinion sprocket and chain on hex

shaft, then replace bearing flanges.

10. Hold wheel so friction disc will not rotate

and secure new friction disc to carrier

with three hex screws removed in

step 2.

11. Replace wheels.

12. Replace bottom cover.

13. Adjust traction drive clutch.

BATTERY (926513)

Charging

1. Place unit on a level surface and shut off

engine.

2. Disconnect negative (–) cable first, then

positive (+) cable.

3. Loosen wing nut and remove battery.

Place battery on bench or other well-

ventilated place.

4. Connect positive (+) lead of charger to

positive (+) terminal, and negative (–)

lead to negative (–) terminal.

5. Charge the battery at two and a half

amps for ten hours.

6. Reinstall battery into unit and connect

positive (+) cable first, then negative (–)

cable.

Replacing

Use U1R or U1L; 240 CCA minimum @ 18°C

type batteries.

TRACK TENSION ADJUSTMENT

(926324)

(Figure 35 and 36)

Check the track tension by applying pressure

on the track midway between the upper and

rear track rollers. Deflection should be

approximately 9.6 mm (Figure 35).

If deflection is excessive, tighten the track

tension.

If unit pulls to the left or right when a straight

path is desired adjust the track tension. If the

unit is pulling to the left, tighten the left track

adjuster. If the unit is pulling to the right,

tighten the right track adjuster.

To adjust (Figure 36):

1. Tighten the adjuster nut to tighten the

track tension.

Loosen the adjuster nut to reduce track

tension.

2. Check that unit tracks straight with no

pulling to either side.

HEIGHT ADJUSTER CABLE

ADJUSTMENT (926324)

(Figure 37)

1. Make sure that height adjustment lock

finger is fully engaged.

2. Loosen jam nut on cable adjustment

barrel.

3. Turn the adjustment barrel to remove all

cable slack and bring the overtravel arm

until it makes slight contact with the right

end of the slot in the height adjuster lock

finger.

4. Tighten the jam nuts.

Figure 34

OS7225

1. Cap Screw

2. Torx Screw

3. Friction Disc

4. Pinion

Sprocket

5. Bearing Cap

6. Hex Shaft

7. Drive Plate

Assembly

8. Stop Bolt

Figure 35

9.6 mm

OS7226

Figure 36

Track

Adjusters

OS7228

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 44 45

Comments to this Manuals

No comments

Ariens Sno-Thro 926 Series Specifications Page 35

Comments to this Manuals

Related products and manuals for Garden tools Ariens Sno-Thro 926 Series