Ariens Power Brush 36 Specifications download pdf (Page 23)

GB - 23

TRACTION DRIVE CLUTCH

ADJUSTMENT

(Figure 16)

If drive slips, adjust traction clutch to

compensate for friction disc wear.

To adjust traction clutch:

1. Loosen jam nut on traction cable

adjustment barrel. Turn the adjustment

barrel down to shorten cable and

remove all cable slack.

2. With the traction clutch disengaged

check that the drive plate assembly

lightly touches to stop screw inside the

frame (Figure 16).

ATTACHMENT DRIVE BELTS

REPLACEMENT

1. Place the unit into the service position

(See Service Position on page 16).

2. Using new attachment drive belts (Part

Number 07200601), place unit into the

operating position (See Operating

Position on page 17).

TRACTION DRIVE BELT

REPLACEMENT

(Figure 16 and 17)

1. Remove attachment drive belts (See

Attachment Drive Belts Replacement on

page 23).

2. To gain belt clearance, back out the stop

screw from the frame until the drive plate

assembly can swing past it (Figure 16).

3. Pull idler away from traction drive belt

and remove belt from engine sheave. It

may be necessary to turn engine pulley

using recoil handle (Figure 17).

WARNING: ALWAYS remove

key and-or wire from spark plug

before assembly, maintenance

or service. Unintentional engine

start up can cause death or

serious injury.

Figure 15

OS7196

Check belt finger clearance here. With the

attachment clutch engaged, there should

be less than 1/8 in. (3 mm) clearance

between the belts and the belt finger. The

belt finger should not touch the belts.

1. Mounting Hardware

2. Belt Finger

1

2

Figure 16

1. Traction Drive Belt

2. Engine Sheave

3. Attachment Drive Belts

4. Belt Finger

5. Attachment Belts Idler

6. Attachment Pulley

7. Attachment Idler Adjustment Nut

8. Traction Belt Idler

9. Traction Drive Pulley

10.Drive Plate Assembly Stop Screw

1

2

3

4

5

8

9

6

Some components removed for clarity

of illustration.

7

10

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Comments to this Manuals

No comments