Ariens 1024 Specifications download pdf (Page 22)

GB - 22

DEFLECTOR REMOTE (924116,

505, 506)

Deﬂector must stay in selected position while

throwing snow.

If deﬂector does not stay in set position:

1. Tighten nut beneath the control panel to

increase friction on pressure ﬂange

(Figure 12).

If deﬂector does not follow full range of travel:

1. Push deﬂector remote all the way forward.

2. Loosen adjusting nuts on cable support

bracket.

3. To adjust the deﬂector lower:

Slide cable down. Tighten bottom nut.

4. To adjust deﬂector higher:

Slide cable up. Tighten top nut.

5. Check travel and repeat adjustment as

necessary.

DISCHARGE CHUTE

If chute does not stay in position while

operating, tighten nut on carriage bolt at pivot

point to increase tension on spring (Figure 13).

Smooth and easy rotation of properly

lubricated chute with crank is obtained by

adjusting pinion and chute gear teeth so they

mesh together.

RUNNERS

Runners should be adjusted (Figure 14) as

conditions require.

1. Position unit on a hard, ﬂat, smooth level

surface.

2. Adjust runners by inserting a spacer of

desired thickness under center of scraper

blade, loosen runner hardware, slide

runners to ﬂat surface. Allow 1/8 in

(3 mm) between scraper blade and hard

smooth surfaces. Allow 1-1/4 in (30 mm)

between scraper blade and uneven or

gravel surfaces. Retighten hardware.

NOTE: Keep housing level by adjusting

runners equally.

Figure 12

1. Nut

2. Pressure Flange

3. Adjusting Nuts

4. Cable Support Bracket

OS0280

1

2

3

4

Figure 13

1. Pinion

2. Chute Gear

3. Carriage Bolt

4. Spring

DS0113

1

2

3

4

Figure 14

1. Runner

2. Runner Hardware

1

2

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 32 33

Comments to this Manuals

No comments