Ariens Sno-Thro 932105 - 8526 User Manual download pdf (Page 25)

GB - 25

2. Turn the adjustment barrel up the cable to

decrease the distance between clutch

lever and handlebar.

Turn the adjustment barrel down the cable

to increase the distance between clutch

lever and handlebar.

3. Check traction clutch lever distance and

repeat adjustment steps if necessary.

4. Tighten jam nut on traction cable

adjustment barrel.

FRICTION DISC REPLACEMENT

Remove (Figure 22 and 23)

1. Shut off engine, remove key, disconnect

spark plug wire, and allow unit to cool

completely.

2. Place unit on a level surface and tip unit up

onto front housing.

3. Remove wheels.

4. Remove bottom cover.

5. Disconnect shift rod from speed selector

arm.

6. Carefully tap roll pins out of hex shaft.

7. Remove outside bearing flange and

bearing from each side of unit.

8. Remove friction disc from shift carrier.

9. Remove roller chain from sprocket on hex

shaft.

10. Remove spacer from hex shaft.

11. Hold shift carrier and slide hex shaft slowly

to the right.

12. Slide shaft only far enough to remove the

old friction disc from hex shaft.

Install (Figure 22 and 23)

1. Place flat side of new friction disc against

shift carrier.

2. Hold shift carrier, slide hex shaft back

toward the left through roller chain and

spacer, and through the opening in the

side of the unit.

3. Install roller chain on sprocket teeth of hex

shaft.

4. Install bearings and outside bearing

flanges.

CAUTION: Remove fuel from fuel

tank prior to placing unit in service

position.

Figure 22

1. Traction Clutch Cable

2. Adjustment Barrel

3. Jam Nut

4. Speed Selector Arm

5. Shift Rod

OS6825

4

5

1

2

3

Figure 23

OS5000

1. Roller Chain

2. Roll pin

3. Hex Shaft

4. Friction Disc

5. Speed Fork

6. Shift Carrier

7. Outside Bearing

Flange

8. Ball Bearing

9. Inside Bearing

Flange

10.Spacer

1

2

3

4

5

6

7

8

9

5

6

4

3

10

9

8

7

2

2

1 2 ... 20 21 22 23 24 25 26 27 28 29 30

Comments to this Manuals

No comments