Ariens 932105 8526 932506 8526 Specifications download pdf (Page 19)

GB - 19

GENERAL LUBRICATION

IMPORTANT: Wipe each fitting clean before

and after lubrication.

IMPORTANT: DO NOT allow grease or oil to

get on friction disc, friction plate or belts.

NOTE: Apply Stens Mix Hi-Temp Grease or

equivalent to the lubrication fittings. See

Service Parts.

Sno-Thro should be lubricated (Figure 12) at

beginning of season or every 25 operating

hours.

Auger Shaft

NOTE: To grease auger shaft, remove shear

bolt nuts, and shear bolts. Turn auger on shaft

while applying grease at zerk fittings. Replace

shear bolt per instructions in Service and

Adjustments.

DEFLECTOR REMOTE

Deflector must stay in selected position while

throwing snow.

If deflector does not stay in set position:

1. Tighten nut beneath the control panel to

increase friction on pressure flange

(Figure 13).

If deflector does not follow full range of travel:

1. Push deflector remote all the way

forward.

2. Loosen adjusting nuts on cable support

bracket.

3. To adjust the deflector lower:

Slide cable down. Tighten bottom nut.

4. To adjust deflector higher:

Slide cable up. Tighten top nut.

5. Check travel and repeat adjustment as

necessary.

OS1374

OS1731

Figure 12

Grease

Oil

SERVICE AND ADJUSTMENTS

WARNING: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 29 30

Comments to this Manuals

No comments

Ariens 932105 8526 932506 8526 Specifications Page 19

Comments to this Manuals

Related products and manuals for Snow throwers Ariens 932105 8526 932506 8526