GB - 13
Chute Handle (932048)
IMPORTANT: If chute does not stay in set position,
adjust as directed in Discharge Chute (932045, 046,
047) on page 19, or repair before operation.
Rotate the Chute with Discharge Chute Handle.
Always stand opposite the direction of snow discharge
when rotating the discharge chute.
IMPORTANT: DO NOT force frozen chute controls. If
frozen, take to warm place until controls are free.
Axle Lock Pin
(Figure 10)
Use the axle lock pin to lock or unlock the right or left
wheel. Lock both wheels to increase traction; unlock
one wheel to allow for easier turning of the unit.
NOTE: Unit will not drive with both wheels unlocked.
Scraper Blade
The scraper blade allows the back of the housing to
keep better contact with the surface being cleared. It
also prevents damage to the housing from normal
wear.
IMPORTANT: DO NOT allow Scraper Blade to wear
too far or Auger/Impeller housing will become
damaged.
Runners
The runners control the distance between the scraper
blade and the ground. Adjust runners equally to keep
blade level with the ground. Refer to Pre-Start on
page 14 for recommended settings.
FILLING FUEL TANK
Fuel Shut-Off Valve
IMPORTANT: The fuel shut-off valve MUST be in the
closed position prior to transporting the unit.
The fuel shut-off valve has two positions:
To add fuel to fuel tank:
1. ALWAYS place unit in open or well-ventilated
area.
2. Stop engine and allow to cool.
3. Clean Fuel Cap and surrounding area to prevent
dirt from entering Fuel Tank.
4. Remove Cap.
IMPORTANT: DO NOT use gasohol or gasoline
containing alcohol. See Engine Manual for correct type
and grade of fuel.
5. Fill fuel tank to within 1/2 in. (1.2 cm) below
bottom of filler neck with unleaded gasoline.
NOTE: Tank capacity is 3.5 qt (3.3 L) (932046), 3.0 qt
(2.8 L) (932045), or 2 qt (1.96 L) (932047, 048).
6. Replace Fuel Cap and tighten.
7. ALWAYS clean up any spilled fuel.
Figure 10
Wheel Unlocked
Wheel Locked
Axle Lock Pin
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
Figure 11
Open Position: Use this
position to run the unit.
Closed Position: Use this
position to service, transport,
or store the unit.
932046, 047, 048
Figure 12
On Position: Use this position
to run the unit.
Off Position: Use this position
to service, transport, or store
the unit.
932045
Comments to this Manuals