Ariens 924119 Specifications download pdf (Page 10)

GB - 10

7. Install wing nut and bolt removed in step 2 onto

shift rod and tighten hardware.

Install Discharge Chute and Crank

(119,120,333,334)

1. Grease discharge chute ring on blower housing

(if not already greased).

2. Slide chute ring under front clip on blower

housing and put chute on housing.

3. Remove mounting hardware from top of engine.

4. Secure chute by fastening chute strap to engine

with hardware just removed.

5. Slide chute crank rod through bracket under

handlebar and through hole in panel.

6. Align chute crank rod with the universal joint on

chute and fasten with spring clip.

Install Discharge Chute - Electric Rotation

(502,503)

1. Remove chute motor cover.

2. Remove the six (6) nuts from ring gear (Figure 6).

3. Remove two (2) half rings.

4. Position Discharge Chute over threaded studs

with the chute opening facing the electric motor.

5. Replace the half rings.

6. Replace the six (6) nuts and tighten to 120 in. lbs.

torque.

7. Replace chute motor cover.

Connect Battery (333,334,502,503)

1. Remove wing nuts from battery cover.

2. Install wire lead to battery terminal.

3. Install battery cover and tighten wing nuts.

Deﬂector Remote (502,503,119)

1. Slide cable end through hole on bracket on left

side of chute.

2. Attach cable eye to stud on deﬂector. Hold in

place with ﬂat washer and e-ring.

3. Check deﬂector travel. Adjust nut on cable end

under handlebar to obtain full travel.

Check Attachment Clutch

Clutch cable spring should expand approximately 3/8”

(9mm) beyond free state when clutch is engaged.

1. When clutch is disengaged, lower end of clutch

arm should return to its maximum down position,

with slight amount of slack in control cable.

2. If proper spring extension is not obtained, adjust

Attachment Idler per

Service and Adjustments

Check Function of Dual Handle Interlock

Without the engine running, press down (engage) both

clutch levers. Release attachment clutch lever.

Attachment clutch should remain engaged until traction

clutch lever is released, then both clutches

must

disengage.

Check Tire Pressure

Check tire pressure and adjust to 14 PSI (96.5 kNm

Check Auger Gearcase Oil

Check oil level in auger gearcase (see

Service and

Adjustments

Check Engine Crankcase Oil

IMPORTANT:

Engines on all Sno-Thro models are

shipped with oil in crankcase. Refer to Engine Manual

for detailed instructions.

Fill Engine Fuel Tank

Refer to Engine Manual for proper fuel type and tank

capacity.

1. Ring Gear Nuts

2. Half Rings

3. Discharge Chute

Figure 6

OS1930

Figure 7

1. Cable Eye

2. Flat Washer and E-Ring

3. Deﬂector Cable

OS1981

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

Comments to this Manuals

No comments

Ariens 924119 Specifications Page 10

Comments to this Manuals

Related products and manuals for Snow throwers Ariens 924119