Ariens 921003 - ST1130DLE Specifications download pdf (Page 27)

GB - 27

Speed Selector Adjustment

To adjust (Figure 33):

1. Disconnect adjustment pivot pin from

speed selector lever by removing hair

pin.

2. Place the speed selector in the fastest

forward speed position.

3. Turn the speed selector lever straight

down towards the ground as far as it will

go.

4. Thread the adjustment pivot pin along

the shift rod until it aligns with the mating

hole on the speed selector lever. Insert

the pivot pin into hole.

5. Secure adjustment pivot pin with hairpin.

6. Make sure the speed selector shifts into

each speed position.

7. Check forward and reverse speeds:

a. Start unit.

b. Shift speed selector into the first

forward speed.

c. Engage the traction clutch. Unit

should move forward.

d. Stop unit.

e. Shift speed selector into first

reverse speed.

f. Engage the traction clutch. Unit

should move backward.

g. Shut off unit.

8. Adjust pivot pin on the shift rod as

necessary so unit travels forward when

speed selector is in first forward position

and travels backward when speed

selector is in first reverse position.

9. Connect the pivot pin to the speed

selector arm with the hardware removed

in step 1.

Attachment Clutch/Brake

Adjustment

(Figures 34, 35 and 36)

Remove Attachment Cable Slack

1. Remove the belt cover.

2. Loosen jam nut on cable adjustment

barrel, and then turn the adjustment

barrel up or down to lengthen or shorten

cable and remove all cable slack. See

Figure 34.

Figure 32

OS7177

1. Spring

2. Nut

1

2

1

2

921001

IMPORTANT: IMPROPER

ADJUSTMENT could result in

unexpected movement of auger

and impeller causing death or

serious injury. Auger / impeller

must stop within 5 seconds when

Attachment Clutch/Impeller Brake

lever is released.

Figure 33

1. Shift Rod

2. Adjustment Pivot Pin

3. Speed Selector Lever

4. Hairpin

2

3

1

4

OS7186

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Comments to this Manuals

No comments