Ariens Pro-24 HWM SP Specifications download pdf (Page 22)

GB - 22

REPLACE OIL FILTER

Replace oil filter every 50 hours of use or

annually.

1. Clean dirt and debris from oil filter and

surrounding area.

2. Place mower in the Service Position.

See SERVICE POSITION on page 20.

3. Place a suitable container below engine

oil fill tube and remove cap to allow oil to

drain from tube.

4. Turn oil filter counterclockwise to

remove. See Figure 23.

5. Apply a thin coat of oil onto seal of new

filter.

6. Install new filter and hand tighten

securely.

7. Tip mower back down onto its wheels.

8. Add engine oil. Refer to Engine Manual

for instructions and proper oil type.

9. Install oil fill cap.

10. Remove plastic from fuel cap and

connect spark plug wire to spark plug.

CHECK MUFFLER

Check muffler for debris, cracks, wear, or

other damage every 50 hours of operation.

REPLACE SPARK PLUG

Spark plug should be replaced every 100

hours of operation or annually. See engine

manual for specific information.

NOTE: Loose spark plug wire terminals can

cause sparking. Replace terminal if

damaged.

Figure 23

Oil Filter

Oil Fill Tube with Cap/Dipstick

CAUTION: Replace worn-out

mufflers immediately. Continued

use could result in fire or

explosion.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 41 42

No comments

Ariens Pro-24 HWM SP Specifications Page 22