Ariens A173K22 (96136100) Owner's Manual download pdf (Page 14)

TO ADJUST HANDLE

The handle can be mounted in a high or

low position. The mounting holes in the

bottom of lower handle are off center for

raising or lowering the handle.

1. Remove upper handle and wire tie(s)

securing cable(s) to lower handle,

2, Remove hairpin cotters from lower

handle bracket mounting pin.

3, Squeeze lower handle in to remove it

from mounting pins.

4. Turn lower handle over to raise or

lower handle.

5. Squeeze lower handle in and position

holes onto mounting pins on handle

bracket.

6, Reassemble upper handle and all parts

removed from lower handle.

SQUEEZE

TO ADJUST

\

Lower

ROTATE

ENGINE

ENGINE SPEED

Your engine speed has been factor# set.

Do not attempt to increase engine speed

or it may result in personal injury. !f you

believe that engine is running too fast or

too slow, take your mower to a qualified

service center for repair and adjustment.

CARBURETOR

Your carburetor is not adjustable. If your

engine does not operate properly due to

suspected carburetor problems, take your

lawn mower to a qualified service center

for repair and/or adjustment.

IMPORTANT. Never tamper with the

engine governor, which is factory set for

proper engine speed. Overspeeding

the engine above the factory high speed

setting can be dangerous, If you think

the engine-governed high speed needs

adjusting, contact a qualified service

center, which has proper equipment and

experience to make any necessary adjust-

ments.

Immediately prepare your lawn mower for storage at the end of the season or if the unit

will not be used for 30 days or more.

LAWN MOWER

When lawn mower is to be stored for a

period of time, clean it thoroughly, remove

all dirt, grease, leaves, etc. Store in a

clean, dry area.

1. Clean entire lawn mower (See

"CLEANING" in the Maintenance sec-

tion of this manual).

2. Lubricate as shown inthe Maintenance

section of this manual.

3. Be sure that all nuts, bolts, screws, and

pins are securely fastened. Inspect

moving parts for damage, breakage

and wear. Replace if necessary.

4. Touch up all rusted or chipped paint

surfaces; sand lightly before painting.

14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Comments to this Manuals

No comments