Ariens 992807-ProZoom 60 Specifications download pdf (Page 31)

PROBLEM

Engine Idling Poorly

Engine Backfires

Engine Runs But Unit

Won't Move

Unit Loses Power or

Hydraulic System

Overheats

Loss of Power or

System Will Not

Operate in Either

Direction

Engine Overheats

Engine Stalling While

Blades Engaged

Low Engine Oil

Pressure

High Oil Consumption

Engine Will Not Turn

Over

Engine Turns Over But

Doesn't Start - There

Is Spark at Spark Plug.

PROBABLE CAUSE

1. Carburetor incorrectly adjusted.

2. Improper spark plug gap.

1. Carburetor adjusted incorrectly.

1. Drive belt loose or broken.

2. Hydraulic reservoir oil low.

CORRECTION

1. Contact Dealer.

2. Check and regap spark plugs.

1. Contact Dealer.

1. Tighten or replace drive belt.

2. Refill reservoir.

3. Pump bypass valve open.

4. Hydraulic oil filter plugged.

3. Close bypass valve.

4. Replace hydraulic oil filter.

5. Bad pump or motor.

1. Hydraulic oil reserve too low.

2. Hydraulic oil reservoir out of cap.

1. Restrictions in air cleaner.

2. Poor compression.

5. Contact Dealer.

1. Refill reservoir.

2. Overfill or water contaminated.

1. Service air cleaner.

2. Contact Dealer.

3. Steering linkage needs adjustment.

4. Hydraulic bypass valve open.

5. Pump belt broken or worn.

3. Contact Dealer.

4. Close bypass valve.

5. Replace belt.

6. Pump belt off of pulley. 6. Reinstall belt on pulley.

1. Air intake screen clogged. 1. Service air intake screen.

2. Cooling fins clogged. 2. Clean fins.

1. Operator not in seat. 1. Sit on seat.

2. Faulty safety system. 2. Contact Dealer.

3. Spindle bearing failure. 3. Contact Dealer.

4. Blades locked by foreign matter. 4. Clean underside of deck.

1. Low oil level. 1. Add oil.

2. Oil diluted or too light. 2. Change oil and locate source of

contamination.

1. Numerous possibilities. 1. Contact Dealer.

1. Dead Battery. 1. Charge battery. See Battery Maintenance

on page 21.

2. Bad ground connection.

3. Poor terminal connection at battery.

4. Poor wiring harness connections.

5. Bad parking brake switch.

6. Bad PTO switch.

7. Steering control levers not in park position.

8. PTO switch engaged.

9. Operator not in seat.

10. Blown fuse.

1. No fuel or line plugged.

2. Bad fuel solenoid.

3. Dirt in fuel filter.

4. Dirt or water in fuel or stale fuel.

5. Incorrect fuel in fuel system.

6. Choke is not on.

2. Correct the connection.

3. Correct the connection.

4. Correct the connection.

5. Contact Dealer.

6. Contact Dealer.

7. Place steering control levers in park

position.

8. Disengage switch.

9. Sit in seat.

10. Replace fuse.

1. Fill tank or replace line.

2. Contact Dealer.

3. Replace fuel filter.

4. Contact Dealer.

5. Drain tanks and replace with proper fuel.

6. Move choke lever to on position.

GB-31

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 115 116

Comments to this Manuals

No comments

Ariens 992807-ProZoom 60 Specifications Page 31

Comments to this Manuals

Related products and manuals for Lawnmowers Ariens 992807-ProZoom 60