Ariens GARDEN TRACTORS 931013 S-14G User Manual Page 36

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 35
CHECK TRANSAXLE OIL LEVEL
The oil level in the rear end should be checked every 25
hours of operation or monthly.
A
CAUTION.Proper oil level Is essential for protection
against severe damage to the transaxle.
Use the following procedure to check the transaxle
oil level:
1. Drive tractor onto level ground.
2. Stop engine.
3. Wipe dirt from around the oil level filler plugs. See
Figure 6A.
4. Remove filler plug. Oil level should level with the filler
plug hole, see Figure 6A.
5. if necessary, use a small funnel to add sufficient MP-90
oil to bring the oil up to the proper level. Replace plug.
FILL FUEL TANK
Fill fuel tank with regular grade gasoline. Do not use
premium gasoline. Figure 5A.
Be very careful to prevent dirt and foreign materials from
entering the transaxle when checking the oil.
A
IMPORTANT: Do not push or tow tractor at high
speed. Load tractor on truck or trailer when delivering
to purchaser.
CHECK TIRE PRESSURE
Inflate tires to pressures shown in the chart below. Use a
low pressure tire gauge for accurate readings.
TIRE SIZE
LOADING
Light Medium
Heavy
Front
(Lawn Work)
(Sno- T(iro)
16 X 6.50 X 8
8 p.s.i. 12 p.s.i. 16 p.s.i.
Rear
23 X 10.50 X 12
(Lawn Work)
6 p.s.i.
(Rotary-Tiller)
8 p.s.i. 10 p.s.i.
Figure 5A
DELIVERY
Using the Owner's Manual as a guide, instruct the cus
tomer as follows:
1. Instruct the customer on the operation of the tractor. 4. Explain maintenance and adjustment instructions.
Emphasize safety and discuss the safety information in the 5. Demonstrate how to mount and dismount attachments.
Owner's Manual. 6. Make certain the customer has his Owner's Manual.
2. Advise customer to change oil in the engine crankcase 7. Explain Ariens Warranty Policy. Fill out and return
after the first five hours of operation. Ariens Warranty Registration Card.
3. Explain how to perform the recommended lubrication and
periodic service.
CHECK SAFETY INTERLOCK SYSTEM
To make sure that the safety interlock system has not become
disconnected or damaged in shipment, check to see that the
tractor will not start unless:
a. The shift lever is in the NEUTRAL position.
b. Implement Power Control Switch is in the OFF (In)
position.
If the engine starts with above controls in any other position,
the safety interlock must be corrected before delivery.
-36-
Page view 35
1 2 ... 31 32 33 34 35 36

Comments to this Manuals

No comments