Ariens 912 User Manual download pdf (Page 6)

Dealer Preparation for Operation

Customer Note: Your Ariens Dealer is expected

to complete these preparation steps and

review important information, including this

manual, with you before or upon delivery of

this unit.

The preparation information is included here

so that you and your dealer may review it

together.

NOTE: All references to “Left”, “Right”,

“Front” and “Rear” are given from operator’s

position.

Steering Wheel

Lubricate column shaft and place steering

wheel onto it; with holes lined up, drive the V4

X 1-3/4” roll pin through holes to secure. (Pin

should have equal spacing on both sides of

steering wheei base.)

1. Steering Wheel

2.

3.

4.

5.

6.

7.

1/4 X 1-3/4” Roll Pin

3/16 X I” Roll Pin

Wesher

Wave Washer

Flanged Bushing

Column Shaft

8. Steering Pinion

Figure 2: Steering Wheel and Shaft

Place washer, wave washer and flanged

bushing on column shaft and column shaft in-

to steering column. Position bottom end of

shaft on steering pinion, line up holes and

secure with two 3/16 X 1” roll pins.

Trap washer, wave wa:sherand flanged bushing

on top of column by%iving the 3/16 XI” roll

pin through hole in column shaft above

washer,

Install plug on right hand side of steering

column.

Seat

Place seat on seat bracket and install cap

screw, lock washer and seat support washer.

Connect seat switch wires to connectors.

Slide seat to a safe comfortable operating

position and tighten cap screw to secure seat

in position.

Engine

IMPORTANT; Engine is shipped without oil in

crankcase. Refer to instructions in Lubrication

and Maintenance Section to fill.

Battery (electric start models)

Battery is shipped without electrolyte. After

removing battery from tractor, fill each ceil

with electrolyte to level indicator. Instructions

for battery removal and charging are in

Lubrication and Maintenance section of this

manual.

Tire Pressure

Riding movver was shipped with tires over in-

fiated to ensure seating of bead. Reduce tire

pressure to 12 PSI before operating unit.

Wheel Brakes

Wheel brakes are properly adjusted at factory.

Test brakes after riding mower Is assembled to

be sure adjustment has not been disturbed in

shipment. Refer to Adjustments Section of

this manual.

1 2 3 4 5 6 7 8 9 10 11 ... 22 23

Comments to this Manuals

No comments