Ariens 911086 - LM21 User Manual download pdf (Page 9)

GB - 10

CONTROLS AND FEATURES

See Figure 1 for locations.

Engine/Blade Control

The engine/blade control must be held against

the handlebar to start the engine and blade.

Releasing the control during operation stops

the engine and blade.

Handlebar

Adjust handlebar to a safe and comfortable

height. Refer to Service and Adjustments for

instructions.

Recoil Starter Handle

When pulled, handle will turn engine over.

CUTTING HEIGHT ADJUSTMENT

Standard Models

To change cutting height, move cutting height

levers one notch at a time on each wheel to

set desired height (Figure 6).

NOTE: Each wheel on mower must be set at

the same height for a level cut.

OM0300

1. Speed Control Rod

2. Hair Pin

3. Speed Control Bell Crank

1

2

3

Figure 5

OPERATION

WARNING: Improper operation can

lead to injury. Learn what the

controls do and how they work.

Thoroughly read and understand

entire Operator Manual.

CAUTION: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

CAUTION: Check function of

Engine/Blade Control regularly.

Improper function of control could

cause injury.

STOP START and RUN

OM1230

DANGER: Avoid injury from rotating

blade.

ALWAYS shut off engine before

adjusting cutting height.

CAUTION: On self-propelled

models, both rear wheels must be

set at same height or traction drive

may not work properly.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Comments to this Manuals

No comments