Ariens 513-517 User Manual download pdf (Page 4)

2 - 4

2.1 SAFETY ALERTS

Look for these symbols to point out

important safety precautions. They

mean:

Attention!

Personal Safety Is Involved!

Become Alert!

Obey The Message!

2.2 SIGNAL WORDS

The safety alert symbol is used in decals on the unit

and with proper operation procedures in this manual.

They alert you to the existence and relative degree of

hazards.

Understand the safety message. It contains important

information about personal safety on or near the unit.

2.3 NOTATIONS

NOTE:

General reference information for proper oper-

ation and maintenance practices.

IMPORTANT:

Specific procedures or information

required to prevent damage to unit or attachment.

2.4 PRACTICES AND LAWS

Practice usual and customary safe working

precautions, for the benefit of yourself and others.

Understand and follow all safety messages. Be alert to

unsafe conditions and the possibility of minor,

moderate, or serious injury or death. Learn applicable

rules and laws in your area.

2.5 REQUIRED OPERATOR TRAINING

Original purchaser of this unit was instructed by the

seller on safe and proper operation. If unit is to be used

by someone other than original purchaser; loaned,

rented or sold, ALWAYS provide this manual and any

needed safety training before operation.

2.6 PREPARATION

Before starting any removal of parts, proper

preparation is very important for efficient work. A clean

work area at the start of each job will allow you to

perform service repairs easily and quickly.

To reduce the incidence of misplaced tools or parts,

place removed components with all attaching hardware

in the disassembly order on a clean work surface.

Organization is a key part of proper reassembly.

Tools, instruments, and parts needed for the job should

be gathered before work is started. Interrupting a job to

locate tools or parts is a needless delay.

2.7 CLEANING AND STORAGE

IMPORTANT:

Never spray unit with water or store unit

outdoors to help prevent sealed bearing rust or

corrosion. Water can seep into sealed bearings and

reduce component life. Bearings are sealed against dirt

and debris only.

A unit that is excessively dirty should be cleaned

before work starts. Cleaning will occasionally uncover

trouble sources. Dirt and abrasive dust reduce the

efficient work life of parts and can lead to costly

replacement.

SECTION 2 - SAFETY

DANGER:

IMMINENTLY HAZARDOUS

SITUATION! If not avoided, WILL RESULT in

death or serious injury.

WARNING:

POTENTIALLY HAZARDOUS

SITUATION! If not avoided, COULD RESULT

in death or serious injury.

CAUTION:

POTENTIALLY HAZARDOUS

SITUATION! If not avoided, MAY RESULT in

minor or moderate injury. It may also be used

to alert against unsafe practices.

CAUTION:

Remove enough fuel so that no

spillage will occur. Remove battery to prevent

spillage of electrolyte.

WARNING:

AVOID SHARP EDGES which

can cut. Movement of parts can cut off fingers

or a hand. Wear gloves, and use extreme

caution when servicing.

1 2 3 4 5 6 7 8 9 ... 43 44

Comments to this Manuals

No comments

Ariens 513-517 User Manual Page 4

Comments to this Manuals

Related products and manuals for Gardening equipment Ariens 513-517