Ariens 915501 Service Manual download pdf (Page 19)

5 - 18

5. Remove the throttle and choke control from the

engine.

6. Remove the electrical wiring from the engine

(charge lead, starter cable, fuel solenoid lead, and

magneto kill wire).

7. Remove fuel line from engine first. Drain fuel from

line back into fuel tank.

8. Disengage the idler spring and remove the drive

belt.

9. Remove the electric clutch and the anti-rotation

bolt.

10.Remove the engine bolts.

11.Lift engine out of the unit and off the frame with a

hoist (engine).

12.Service, overhaul, or replace engine as required.

13.If replacing engine with a new engine, the following

items will have to be removed (if used) from the old

engine. These items will not be included with a new

engine.

Engine sheave and key, mounting hardware, and

engine wiring harness.

5.10 ENGINE INSTALLATION

1. Check the engine base and unit frame for damage

before installing the engine.

2. Place the throttle and choke controls, fuel line, and

electrical wires out of the way prior to installing the

engine.

3. Once the engine is bolted onto the frame, tighten

the mounting hardware.

4. Install the engine sheave, belts, springs, electrical

wiring, throttle, and choke controls.

5. Place the drive belt in position and replace the

tension spring.

6. Install the negative battery cable onto the battery.

7. Install the fuel line.

8. Fill engine with 30W above 32

F (0

C) or 5W30

below 32

F (0

C).

9. Install the engine cover, then test operation and

function of the engine.

10.Check the fluid levels as follows:

a) Start the engine and allow it to reach to

operating temperature. DO NOT operate engine

for more than two minutes.

b) Shut the engine off, wait for engine to cool, and

be sure the engine oil level is between the full and

add marks on the dipstick. If it is below the ad

mark, add recommended oil. DO NOT overfill.

MACHINE

BACK

Figure 12

PE0760

1. Oil Drain Tube

2. Idler Pulleys

3. Spring

4. Drive Belt

WARNING: AVOID EXHAUST FUMES! DO

NOT run engine in an enclosed area.

ALWAYS provide good ventilation and wait

until hazard has been removed.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Comments to this Manuals

No comments

Ariens 915501 Service Manual Page 19

Comments to this Manuals

Related products and manuals for Garden tools Ariens 915501