Ariens SNO-THRO 938017 - SS522EC EN User Manual download pdf (Page 8)

GB - 8

Discharge Chute Assembly

1. Remove bolt and nut from rear of

discharge chute (figure 4).

2. Tip discharge chute up and install

hardware just removed. Tighten

hardware at rear of discharge chute first,

then sides.

Discharge Chute Crank Assembly

(938017, 018, 117)

1. Remove nut from bolt that holds recoil

starter handle bracket in place (figure 5).

2. Pull the chute crank assembly up so hole

in chute crank bracket fits behind/under

lower handle bar and over bolt end.

NOTE: DO NOT pull chute crank bracket past

the lower handle bar or the 48T gear and

spacer will fall off into unit.

3. With crank knob straight up and

discharge chute straight forward, check

that 48T gear meshes with 12T pinion.

Align space and tooth identification

marks.

4. Insert cotter pin (taped to chute crank

assembly) through 48T gear and chute

crank shaft. Slight movement of the

crank shaft or discharge chute may be

needed to align holes.

5. Rotate chute crank to access cotter pin.

Secure pin by bending ends over.

6. Secure chute crank and starter handle to

lower handle bar by reinstalling nut from

step 1.

Fill Engine Fuel Tank

See Filling Fuel Tank on page 11.

Check Function of all Controls

Ensure unit runs and performs properly (see

Operation on page 10).

1

2

3

4

Figure 4

OS1520

1. Discharge Chute

2. Rear Bolt and Nut

3. Chute Handle

4. Side Hardware

IS0212

Figure 5

1

2

3

4

5

6

7

8

1. Chute Crank

2. Identification

Marks

3. 12T Pinion

4. Spacer

5. 48T Gear

6. Cotter Pin

7. Nut

8. Recoil Starter

Handle Bracket

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

Comments to this Manuals

No comments