Ariens SNO-THRO 924326-ST1336LE User Manual download pdf (Page 10)

Discharge Chute

Discharge Chute rotates 230'

Chute Crank Handle

Rotate the Chute with Discharge Chute Crank Handle.

IMPORTANT: DO NOT force frozen Chute controls.

Start engine and run for 3-5 minutes to thaw. If still

frozen, take to warm place until controls are free.

Differential Lock

Differential Lock knob is located on the Left

Wheel Hub. With differential locked power

is applied equally to both wheels.

To engage differential lock:

• Pull and turn knob to “Locked” position

and release (knob will snap in place when

positioned correctly).

To resume differential actlondor transport:

• Pull and turn knob to “Unlocked” position and release.

Scraper Blade

DO NOT allow Scraper Blade to wear or Auger / Impeller

housing will become damaged.

Runners

For operation on gravel surface, lower Runners so that

housing will not pick up gravel. On concrete, blacktop or

packed snow surfaces raise Runners so that Scraper

Blade scrapes clean. To reduce tendency of housing to

ride up over heavy wet or hard-packed snow, remove

Runners and reinstall with their narrow edge down.

Headlight

The Headlight (Optional) operates only when the engine

is running. Adjust the Headlight: loosen the hardware,

position light and retighten hardware.

NOTE: Lamp remains “On” at all times for longer lamp

life. Lamp is more sensitive to fatigue failure when unlit

than when lit.

Pre-Start

Frozen Impeller

IMPORTANT: Before engine start check Impeller to be

sure it is not frozen. With key in “Stop” position, squeeze

Attachment Clutch Lever to Engaged position and pull

Recoil Starter Handle. If Impeller is frozen, (cannot pull

Starter Handle) move unit to a heated area and thaw to

prevent possible damage.

Ambient Temperatures

Allow unit and engine to adjust to the outdoor

temperatures before clearing snow.

Differential Lock

ALWAYS engage differential lock (located in left wheel

hub) for best traction when throwing snow.

Function of Clutches

IMPORTANT: Check Clutch/Brake function before each

use. If the Impeller does not stop quickly when the

Attachment Clutch Lever is released or there is no

noticeable increase in the Lever force before contacting

the Handlebar, adjust as directed in the Adjustments

Section, or repair before operation.

Interlock

Check by pressing down on Clutch Levers (engaging

both clutches). Remove hand from Attachment Clutch

Lever, attachment clutch should remain engaged until

Traction Clutch Lever is released then both clutches

must disengage.

Engine Fuel and Crankcase Oil

Check and add fuel if required. Check that the engine

crankcase oil is full using dipstick. Refer to General

Maintenance Section.

Runners

Check and adjust Runners. Allow 1/8" 3mm) between

scraper blade and hard, smooth surface(s). Allow 1-1/4"

(30mm) between scraper blade an uneven surface(s).

Ariens® 924 SnorThro Rev. 9/98

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Comments to this Manuals

No comments

Ariens SNO-THRO 924326-ST1336LE User Manual Page 10

Comments to this Manuals

Related products and manuals for Cars Ariens SNO-THRO 924326-ST1336LE