Ariens 991074-Max Zoom 52 Specifications download pdf (Page 23)

GB - 23

4. Start the engine, run engine at full

throttle, and release the parking brake.

5. Move the steering levers from Forward

to Reverse several times to make sure

controls are free. Then return steering

levers to neutral position.

6. Check wheel(s) for movement.

NOTE: The right and left hydraulic pumps are

adjusted the same way.

7. If a wheel moves, adjust the return to

neutral mechanism on the hydraulic

pump:

a. Loosen the return to neutral screw

on the pump.

b. Slowly move the speed and

direction control bracket clockwise

or counterclockwise until the

wheel stops moving.

c. Hold the stop bracket in position

and tighten the return to neutral

screw on the pump.

8. Move steering levers from Forward to

Reverse several times and return

steering levers to neutral position.

Check wheel(s) for movement.

9. If wheel is still moving, repeat steps 7

and 8.

10. Shut OFF engine.

11. Replace drive wheels.

Aligning the Steering Levers

(Figure 14)

1. Shut OFF engine. Engage parking

brake. Remove the ignition key.

2. Place seat in the service position (See

Service Position on page 18).

3. Loosen brake interlock on the same side

as steering lever to be adjusted.

4. Loosen tie rod jam nuts and turn tie rod

until steering levers are aligned.

5. Tighten jam nut on tie rod, tighten brake

interlock.

Figure 13

Axle Direction

Return to Neutral

Adjusting Screw

Speed and

Direction

Control Arm

1. Tie-Rod Jam

Nut

2. Tie-Rod

3. Steering

Lever

4. Brake

Interlock

5. Hydrostatic

Transmission

Figure 14

OF3381

1

2

3

4

5

1

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Comments to this Manuals

No comments