Ariens 991074-Max Zoom 52 Specifications download pdf (Page 14)

GB - 14

The alert starts counting down two hours

before the maintenance is due. The meter

flashes the word, "Now," when it reaches the

maintenance time.

Press and hold the toggle button to reset the

maintenance clock to zero after perfoming

the service.

NOTE: The hour meter is preprogrammed for

the initial oil change at 25 hours and for 100

hours thereafter. The hour meter is

programmed for the initial hydraulic oil and

filter change at 75hours and for 400 hours

thereafter.

FILLING FUEL TANK

Add fuel to Fuel Tank as needed. See your

Engine Manual for correct type and grade of

fuel.

To add fuel to the fuel tank:

1. Clean fuel caps and surrounding area to

prevent dust, dirt, and debris from

entering fuel tanks.

2. Remove fuel caps.

IMPORTANT: Refer to Engine Manual for

correct type and grade of fuel.

3. Fill fuel tank to the bottom of filler neck.

See Specifications on page 31 for fuel

tank capacity.

IMPORTANT: DO NOT OVERFILL! This

equipment and/or its engine may include

evaporative emissions control system

components, required to meet EPA and/or

CARB regulations, that will only function

properly when the fuel tank has been filled to

the recommended level. Overfilling may

cause permanent damage to evaporative

emissions control system components. Filling

to the recommended level ensures a vapor

gap required to allow for fuel expansion. Pay

close attention while filling the fuel tank to

ensure that the recommended fuel level

inside the tank is not exceeded. Use a

portable gasoline container with an

appropriately sized dispensing spout when

filling the tank. Do not use a funnel or other

device that obstructs the view of the tank

filling process.

4. Replace fuel cap and tighten.

5. ALWAYS clean up spilled fuel.

GASOLINE

IMPORTANT: ALWAYS use gasoline that

meets the following guidelines:

• Clean, fresh gasoline.

• A minimum of 87 octane/87 AKI (91

RON). High altitude use may require a

different octane. Consult your engine

manual.

• Gasoline with up to 10% ethanol

(gasohol) or up to 10% MTBE (methyl

tertiary butyl ether) is acceptable.

• Use of any gasoline other than those

approved above will void the engine

warranty. If the pumps are not marked

for the content of alcohol or ethers,

check ethanol and MTBE levels with

the fuel supplier.

• Do not modify the fuel system to use

different fuels.

• Never mix oil and gasoline.

NOTE: All gasoline is not the same. If the

engine experiences starting or performance

problems after using a new gasoline, switch

to a different fuel provider or fuel brand.

IMPORTANT: Excessively oxygenated or

reformulated fuels (fuels blended with

alcohols or ethers) can damage the fuel

system or cause performance problems. If

any undesirable operating problems occur,

use a gasoline with a lower percentage of

alcohol or ether.

WARNING: AVOID INJURY.

Read and understand entire

Safety section before proceeding.

Display

Toggle Button

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Comments to this Manuals

No comments