Ariens 946150 ST622 CARB User Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 21
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
GB - 8
To reduce fire hazard and overheating, keep
equipment free of grass, leaves, debris or
excessive lubricants.
Use extra care when approaching blind
corners, shrubs, trees, or other objects which
may obscure vision.
DO NOT trim at too fast a rate. DO NOT
change engine governor setting or over-speed
the engine.
Do not operate trimmer on gravel or on loose
material such as sand. Stop trimmer when
crossing gravel drives, walks, or roads to
prevent damage or injury from thrown objects.
DO NOT pull trimmer backwards unless
absolutely necessary. Look down and back,
especially for small children, before and while
moving backwards.
DO NOT operate on steep slopes.
NEVER leave unit unattended on a slope.
Chock wheels if parking on a slope.
Trim across the face of slopes, never up and
down. Be especially cautious when changing
direction on slopes.
This product is equipped with an internal
combustion engine. DO NOT use on or near
any unimproved, forest or brush covered land
unless the exhaust system is equipped with a
spark arrestor meeting applicable local, state
or federal laws. A spark arrestor, if used, must
be maintained in effective working order by the
operator. See your Ariens Dealer or engine
manufacturer’s service center.
Emission Control System Certification
Label
NOTE: Tampering with emission controls and
components by unauthorized personnel may
result in severe fines or penalties. Emission
controls and components can only be adjusted
by EPA and/or CARB authorized service
centers. Contact your Ariens Equipment
Retailer concerning emission controls and
component questions.
Fuel is highly flammable and its vapors can
explode. ONLY use approved fuel containers.
•NO Smoking!
NO Sparks!
NO Flames!
Allow engine to cool before filling fuel
tank.
Never fill containers inside a vehicle or on a
truck or trailer bed with a plastic liner. Always
place containers on the ground away from your
vehicle before filling.
When practical, remove gas-powered
equipment from the truck or trailer and refuel it
on the ground. If this is not possible, then refuel
such equipment on a trailer with a portable
container, rather than from a gasoline
dispenser nozzle.
Keep the nozzle in contact with the rim of the
fuel tank or container opening at all times until
fueling is complete. Do not use a nozzle lock-
open device.
Check fuel supply before starting engine.
DO NOT fill gasoline tank indoors, when
engine is running, or while engine is hot.
Allow engine to cool several minutes before
removing fuel cap.
DO NOT overfill. Allow about 1/4" (6 mm) of
tank space for fuel expansion.
Replace gasoline tank cap securely and clean
any spilled fuel before starting engine.
If fuel is spilled on clothing, change clothing
immediately.
NEVER store fuel inside where there is an
open flame, such as a water heater.
ALWAYS drain fuel outdoors away from ignition
sources.
Avoid Electric Shock. DO NOT disconnect wire
from spark plug while engine is running.
Accidental engine start up can cause death or
serious injury. Except where specifically
recommended, ALWAYS stop engine, wait for
moving parts to stop, allow parts to cool and
disconnect spark plug wire before inspecting,
servicing, adjusting or repairing unit.
Keep unit free of grass, leaves, or other debris
build-up.
Keep equipment in good condition.
Maintain or replace safety and instruction
labels, as necessary.
Follow engine manufacturer’s safety
instructions when servicing engine.
Check all hardware at regular intervals,
especially trimmer head attachment bolts.
Keep all hardware properly tightened.
Before tipping unit, remove fuel.
DO NOT tip the trimmer up or over unless
specifically instructed to do so.
Ensure all wheel blocks, jack stands and tie
downs will support unit during maintenance.
Replace worn-out mufflers immediately.
Continued use could result in fire or explosion.
Sharp edges can cut or amputate fingers or a
hand. Wrap blade or wear sturdy gloves to
service.
Use only replacement parts designed for your
unit. See your Ariens Dealer.
Allow engine to cool before storing in any
enclosure.
ALWAYS clean unit before extended storage.
See engine manual for proper storage.
DO NOT store unit inside a building with fuel in
the fuel tank where any ignition sources are
present.
Use only accessories which have been
approved by Ariens and are properly installed.
Check attachments frequently and replace
worn or damaged components with
manufacturer’s recommended parts.
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 20 21

Comments to this Manuals

No comments