Ariens ST11528DLE User Manual download pdf (Page 8)

GB - 8

Install Discharge Chute Crank

1. Remove the cover from the gear assembly on the

discharge chute.

2. Release the lock teeth on the gear assembly with

your finger and rotate the discharge chute 90

left.

3. Remove and save the hairpin from the control

assembly underneath the control panel.

NOTE: Do not remove the pin installed on the chute

rod.

NOTE: To ensure the discharge chute follows its full

range of travel, make sure the control lever is pushed

all the way to the left before installing and pinning the

chute rod.

4. Align the holes on the end of the chute rod with

the mark on the gear assembly and slide the end

without a pin through the gear assembly, through

the loop on the chute lock cable and into the hex

hole in the control assembly.

IMPORTANT: The loop will prevent the control cable

from contacting the engine or muffler guard. If the loop

gets damaged, loosely tie the cable to the control rod.

NOTE: After the chute rod has been inserted through

the hex hole in the control assembly, placing the unit in

the service position (see Service Position on page 19)

will ease alignment and installation of the hair pin.

5. Secure the chute rod to the control assembly with

the hair pin removed in step 3 using the proper

hole location as shown in Figure 7. Insert the hair

pin with the loop end to the left of the chute rod so

the control assembly follows a full range of travel.

Figure 5

1.Mounting Hardware

2.Discharge Chute

3.Chute Pedestal

4.Discharge Chute

Ring

OS7040

OS7045

Figure 6

1.Chute Rod

2.Gear Cover

3.Control Assembly

4.Hair Pin

OS7060

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Comments to this Manuals

No comments

Ariens ST11528DLE User Manual Page 8

Comments to this Manuals

Related products and manuals for Snow throwers Ariens ST11528DLE