Ariens ST11528DLE User Manual download pdf (Page 29)

GB - 29

FRICTION DISC REPLACEMENT

1. Place unit into service position.

2. Remove bottom cover by removing six hex bolts.

3. With axle locked, hold one wheel so friction disc

will not rotate and remove three cap screws

holding friction disc to carrier.

4. Remove both wheels.

5. Remove right and left bearing flanges from frame.

6. Slide hex shaft to the left enough to remove

pinion sprocket from hex shaft.

7. Slide hex shaft to the right enough to remove

friction disc.

8. Slide new friction disc onto hex shaft.

9. Install pinion sprocket and chain on hex shaft,

then replace bearing flanges.

10. Hold wheel so friction disc will not rotate and

secure new friction disc to carrier with three hex

screws removed in step 3.

11. Replace wheels.

12. Replace bottom cover.

13. Adjust traction drive clutch (see Traction Drive

Clutch Adjustment on page 27).

BATTERY (926500, 501)

Charging

1. Place unit on a level surface and shut off engine.

2. Disconnect negative (-) cable first, then positive

(+) cable.

3. Loosen wing nut and remove battery. Place

battery on bench or other well ventilated place.

4. Connect positive (+) lead of charger to positive

(+) terminal, and negative (–) lead to negative (–)

terminal.

5. Charge the battery at two and a half amps for ten

hours.

6. Reinstall battery into unit and connect positive (+)

cable first, then negative (-) cable.

Replacing

Use U1R or U1L; 240 CCA minimum @ 0°F type

batteries.

Figure 37

OS7225

1.Cap Screw

2.Hex Screw

3.Friction Disc

4.Pinion Sprocket

5.Bearing Cap

6.Idler Hex Shaft

7.Drive Plate Assembly

8.Stop Bolt

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

Ariens ST11528DLE User Manual Page 29

Comments to this Manuals

Related products and manuals for Snow throwers Ariens ST11528DLE