Ariens ST11528DLE User Manual Page 28

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 27
GB - 28
Install new attachment drive belt:
1. Place new attachment belt onto attachment
pulley.
NOTE: Holding down the attachment clutch lever will
make it easier to reconnect the housing and frame.
2. Tip housing and frame back together and secure
with hex bolts.
3. Place belt onto engine sheave.
4. Reposition and secure belt fingers.
IMPORTANT: With clutch lever engaged, belt finger on
the side opposite the belt idler should be less than
1/8 in. (3 mm) from belt, but not touching the belt.
Adjust belt finger as necessary.
5. Check adjustment. See Attachment Clutch/Brake
Adjustment on page 25.
6. Reconnect chute crank and secure with spring
clip. Reconnect chute lock cable and deflector
cable.
7. Replace belt cover.
TRACTION DRIVE BELT REPLACEMENT
NOTE: Replacement will be easier with housing and
frame tipped apart and bottom cover off.
1. Remove attachment drive belt (see Attachment
Clutch/Brake Adjustment on page 25).
2. To gain belt clearance, back out the stop bolt from
the frame until the drive plate assembly can
swing past it (Figure 37).
3. Pull idler away from traction drive belt and
remove belt from idler pulley, engine sheave and
driven pulley (it may be necessary to turn engine
pulley using recoil handle).
4. Install new traction drive belt onto attachment
pulley and engine sheaves.
5. Pull the drive plate assembly toward the friction
disc and tighten the stop bolt.
NOTE: Make sure the drive plate assembly return
spring remains connected to the frame.
6. Replace attachment drive belt (See Replace
Attachment Drive Belt).
Figure 35
1.Pivot Pin
2.Housing Cap Screws
3.Belt Cover
2
3
1
OS7215
Figure 36
1.Traction Drive Belt
2.Engine Sheave
3.Attachment Drive Belt
4.Belt Finger
5.Attachment Belt Idler
6.Attachment Pulley
7.Attachment Idler
Adjustment Nut
8.Traction Belt Idler
9.Traction Drive Pulley
OS7220
1
2
3
4
5
8
9
6
7
WARNING: AUGER / IMPELLER MUST
STOP within 5 seconds when attachment
clutch lever is released or unit damage or
serious injury may result.
Page view 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments