Ariens ST11528DLE User Manual download pdf (Page 15)

GB - 15

Discharge Chute Control

IMPORTANT: If chute does not stay in set position,

adjust as directed in SERVICE AND ADJUSTMENTS

on page 22, or repair before operation.

Rotate the Chute with Discharge Chute Control.

IMPORTANT: DO NOT force frozen chute controls. If

frozen, take to warm place until controls are free.

Heated Handles (926002, 003, 014, 015, 016,

500, 501)

Turn the heated handles switch to the

ON (1) position to activate. Turn the

switch to the OFF (2) position to

deactivate.

Remote Differential (926013, 014, 015, 016,

500, 501)

Squeeze and hold the remote differential lever to lock

differential so both wheels drive and provide better

traction. Release the remote differential lever to allow

easier steering.

If remote differential does not engage or disengage

properly, adjust or repair before operation (see

REMOTE DIFFERENTIAL (926013, 014, 015, 016,

500, 501) on page 23).

Remote Wheel Lock (926002, 003)

Squeeze and release the remote wheel lock to lock the

left wheel for better traction when throwing snow or to

unlock the left wheel for easier steering.

NOTE: The wheel lock will not release when under

load. Do not unlock the wheel while turning. If the

wheel lock will not release, turn the unit slightly left or

right to relieve axle load and release the axle lock.

If remote wheel lock does not lock or unlock properly,

adjust or repair before operation (see REMOTE

WHEEL LOCK (926002, 003) on page 23).

Axle Lock Pin (926001)

(Figure 14)

Use the axle lock pin to lock or unlock the right or left

wheel. Lock both wheels to increase traction; unlock

one wheel to allow for easier turning of the unit.

NOTE: Unit will not drive with both wheels unlocked.

Scraper Blade

The scraper blade allows the back of the housing to

keep better contact with the surface being cleared. It

also prevents damage to the housing from normal

wear.

IMPORTANT: DO NOT allow Scraper Blade to wear

too far or Auger/Impeller housing will become

damaged.

Runners

The runners control the distance between the scraper

blade and the ground. Adjust runners equally to keep

blade level with the ground. Refer to Pre-Start on

page 16 for recommended settings.

Drift Cutters (Figure 15)

Drift cutters break up snow drifts that are taller than the

auger housing and direct the snow into the auger. Store

the drift cutters on the auger housing when not in use.

Install them as shown below so they are taller than the

snow to be cleared.

Figure 13

OS7105

OS1950

Figure 14

Wheel Unlocked

Wheel Locked

Axle Lock Pin

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Comments to this Manuals

No comments

Ariens ST11528DLE User Manual Page 15

Comments to this Manuals

Related products and manuals for Snow throwers Ariens ST11528DLE