Ariens Snow Blower 920006 User Manual download pdf (Page 10)

GB - 10

Check Tire Pressure

Check tire pressure and adjust to the

pressure listed on tire sidewall.

Check Auger Gearcase Oil

Check oil level in auger gearcase (see Check

Auger Gearcase on page 19).

Check Engine Crankcase Oil

IMPORTANT: The engine is shipped with

5W-30 oil in crankcase. Refer to Engine

Manual for detailed instructions.

Fill Engine Fuel Tank

Refer to Engine Manual for proper fuel type

and tank capacity.

Check Function of all Controls

Ensure unit runs and performs properly. Refer

to Operation.

Run-in Attachment Belt

1. Start unit in a well-ventilated area

according to Starting and Shut Off on

page 16.

2. Engage attachment clutch lever and run

attachment for about 15 minutes.

3. Stop unit, wait for all moving parts to

stop, and remove spark plug wire.

4. Adjust belt finger, if necessary. See

Attachment Drive Belt Replacement on

page 22.

5. Adjust clutch idler according to

Attachment Clutch/Brake Adjustment on

page 24.

CAUTION: Avoid injury! Explosive

separation of tire and rim parts is

possible when they are serviced

incorrectly:

• Do not attempt to mount a tire

without the proper equipment

and experience to perform the

job.

• Do not inflate the tires above

the recommended pressure.

• Do not weld or heat a wheel

and tire assembly. Heat can

cause an increase in air

pressure resulting in an

explosion. Welding can

structurally weaken or deform

the wheel.

• Do not stand in front or over

the tire assembly when

inflating. Use a clip-on chuck

and extension hose long

enough to allow you to stand

to one side.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

Comments to this Manuals

No comments