Ariens Promaster 144Z Specifications download pdf (Page 17)

GB - 17

Gravely Dealers will provide any service which may be

required to keep your unit operating at peak efficiency.

Should engine service be required, it can be obtained from a

Gravely Dealer or the engine manufacturer’s authorized

service center.

SERVICE POSITION

1. Place unit on a flat level surface. ALWAYS stop engine.

Ensure unit is secure and will not tip over. Strap and

clamp onto lift if used.

2. Place steering levers in neutral and engage parking

brake.

3. Remove wing knob or hex nut (992310, 311).

4. Tip seat forward (Figure 6).

5. When service is complete, lower seat and secure with

wing knob or hex nut.

HYDRAULIC FLUID

Check Hydraulic Fluid Level

1. Start the unit and run it to operating temperature (about

10 minutes).

2. Cycle the control levers forward and backward two or

three times.

3. For units equipped with a hydraulic deck lift, raise and

lower the deck completely two or three times.

4. Shut OFF engine. Engage parking brake. Remove the

ignition key.

5. Put seat in service position. See SERVICE POSITION

on page 17.

6. Remove any dirt that may be around the cap/dipstick

on the hydraulic reservoir.

7. Remove cap/dipstick.

8. Check hydraulic oil level mark on cap/dipstick.

9. Add 15W50 synthetic oil as needed. Do not overfill.

Change Hydraulic Fluid and Filter

Change the hydraulic oil filter and hydraulic oil every 500

hours. Use Mobil 1 15W50 synthetic oil for best component

life.

1. Clean around dipstick cap and dipstick. Remove

dipstick.

2. Place container under oil filter to catch oil.

3. Remove oil filter.

4. Allow tank to drain.

SERVICE AND ADJUSTMENTS

WARNING: AVOID INJURY. Read and understand

entire Safety section before proceeding.

CAUTION: HOT SURFACES may result in injury.

DO NOT touch engine or drive parts which are hot

from operation. Allow parts to cool before servicing.

CAUTION: Be sure footing is secure to

accomodate weight shift of seat when rotating it into

service position.

1. Service Position

2. Wing Knob

3. Steering Levers

4. Parking Brake

5. Battery

Figure 6

OF3361

WARNING: HYDRAULIC FLUID can result in

severe burns. Fluid in hydraulic system can

penetrate skin and result in serious injury or death.

Be sure to stop the engine before doing any work

on hydraulic parts.

Keep body and hands away from pin holes or

nozzles which expel hydraulic fluid when under

pressure. Use paper or cardboard, not hands, to

search for leaks.

Ensure all hydraulic fluid connections are tight and

all hydraulic hoses and lines are in good condition

before applying pressure to system.

FOREIGN FLUID INJECTED INTO BODY can

result in gangrene. Fluid must be surgically

removed within a few hours by a doctor familiar with

this form of injury.

FULL Mark

Operating

Range

OE0380

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Comments to this Manuals

No comments

Ariens Promaster 144Z Specifications Page 17

Comments to this Manuals

Related products and manuals for Lawnmowers Ariens Promaster 144Z