Ariens Promaster 144Z Specifications Page 21

  • Download
  • Add to my manuals
  • Print
  • Page
    / 60
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 20
7.Adjusttie-rod(s):
Ifthewheelismovinginaforwarddirection:
a.Loosenthejamnutoneachendofthetie-rod.
b.Turntie-rodcounterclockwise(lengtheningthe
distancebetweenthesteeringleverandhydrostatic
transmission)severaltimes.
Ifthewheelismovinginareversedirection:
a.Loosenthejamnutoneachendofthetie-rod.
b.Turntie-rodclockwise(decreasingthedistance
betweenthesteeringleverandhydrostatic
transmission)severaltimes.
8.Returnseattooperatingposition.
9.Startengine.
10.MovesteeringleversfromForwardtoReverseseveral
times.Thenreturnsteeringleverstoneutralposition.
11.ShutOFFengine.
12.Ifwheelisnotmoving,tightenjamnutsontie-rod.The
adjustmentiscomplete.
13.Ifwheelisstillmoving,repeatsteps7through12.
ADJUSTING THE UNIT TO TRACK STRAIGHT
_ ARNING: Prior to adjusting the tracking of the
unit, shut off engine, engage parking brake, and
remove the ignition key.
Check and adjust tire pressure. Increase pressure on side
unit tracks to. DO NOT exceed maximum recommended tire
pressure (See SPECIFICATIONSon page 28).
If tire pressure adjustment does not solve tracking problem,
adjust the limiter bolts on the stop bracket (Figure 12). Front
bolts adjust forward and rear bolts adjust reverse. Lengthen
the limiter bolt (move closer to lever) on side which is too
fast.
3
2
1. Limiter Bolt
2. Jam Nut
3. Steering Lever
4. Stop Bracket
Figure 12
ADJUSTING THE HEIGHT OF THE STEERING
LEVER HANDLES
The handles have three height positions (Figure 13).
1
1. Eccentric Spacer
2. Handle
3. Steering Lever
Position # 1
#2
Position # 3
Figure 13 OF357O
1. Remove the spacer, handle, and eccentric spacer from
the steering lever.
NOTE: Position the right and left handles at the same height
position.
2. Install the spacer, handle, and eccentric spacer in the
appropriate height position. Do not tighten the nut
holding the eccentric spacer.
3. Turn the eccentric spacer until the right and left
handles are the same height. Tighten nut.
GB-21
Page view 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 59 60

Comments to this Manuals

No comments