Ariens 911410-WAW 34 Specifications download pdf (Page 19)

_o_l V_4_Im]V_4m_ll_l / _vj1:1_III__]

,_ CAUTION: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

PTO CLUTCH

WARNING: If you cannot adjust

the controls so the unit drives

properly, immediately take the unit

to your local authorized dealer for

repairs.

1. Test the PTO clutch adjustment.

With the clutch disengaged, the blade

brake pad should touch the upper pulley.

With the clutch engaged, the blade

brake pad should not touch the upper

pulley and the deck belt should be under

tension.

2. Loosen the lock nut on the cable

adjuster under the dash panel.

3. Turn the adjuster body to tighten or

loosen the clutch cable.

NOTE: There must be some slack in the

clutch cable with the clutch disengaged.

4. Tighten the lock nut to hold the

adjustment.

IMPORTANT: If you cannot adjust the PTO

clutch or if it fails to operate properly,

immediately take the unit to your Ariens

dealer for repair.

1. Cable 3. Check

Adjuster Slack

2. Lock Nut

Figure 12

Forward/Reverse Drive Controls

WARNING: If you cannot adjust

the controls so the unit drives

properly, immediately take the unit

to your local authorized dealer for

repairs.

After new belts have been worn in or if the

drive seems to be losing power, the drive

control cable may need adjustment.

Adjust both drive controls the same way.

1. Loosen the lock nut on the drive lever.

2. Turn the cable adjuster to tighten or

loosen the cable.

3. Tighten the lock nut to hold the

adjustment.

4. Test the drive.

Unit should move forward when the

drive control is squeezed and it should

coast to a stop when the drive control is

released.

NOTE: The reverse drive control has been

removed from the unit for clarity of the

illustration.

1. Cable

Adjuster

2. Lock Nut

Figure 13

GB - 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 61 62

Comments to this Manuals

No comments