Ariens 911214 Pro21XD User Manual download pdf (Page 14)

GB - 14

OPTIONAL CONTROLS

Primer Bulb

Push the primer bulb in to add fuel for easier

engine start.

Wheel Drive Control (self-propelled

models)

NOTE: Engine must be running for wheel

drive to propel unit.

To drive forward:

Slowly pull the wheel drive control toward

you until you reach a comfortable ground

speed. Hold the wheel drive control in this

position to maintain the speed.

To stop:

Release wheel drive control.

Speed Control Knob

The speed control knob stops the wheel drive

control’s travel which limits the unit’s

maximum forward speed.

Turn the speed control knob

counterclockwise to increase the unit’s

maximum forward speed. Turn the speed

control knob clockwise to decrease the unit’s

maximum forward speed.

Fuel Shutoff Valve

IMPORTANT: The fuel shutoff valve MUST

be in the closed position prior to transporting

the unit.

Open the fuel shutoff valve to operate the

unit. Close the fuel shutoff valve when

storing, transporting or servicing the unit.

Fuel shutoff valve

open.

Fuel shutoff valve

closed.

FILLING THE FUEL TANK

To add fuel to fuel tank:

1. Put unit in open or well-ventilated area.

2. Stop engine and allow to cool.

3. Clean fuel cap and surrounding area.

4. Remove cap.

IMPORTANT: See engine manual for correct

type and grade of fuel.

5. Fill fuel tank to within 1/4 in. (0.63 cm)

below bottom of filler neck with unleaded

gasoline. See SPECIFICATIONS on

page 25.

6. Replace fuel cap and tighten.

7. ALWAYS clean any spilled fuel.

MOWER SET-UP

CAUTION: Unit will move forward

at engine start if wheel drive

control is engaged. ALWAYS

release wheel drive control before

starting unit.

Figure 12

Figure 13

CAUTION: DO NOT operate

mower unless either side

discharge cover or side discharge

deflector is installed. Thrown

objects may cause damage or

injury. Never operate unit with rear

door open unless grass bag is in

place.

CAUTION: If clog or obstruction

prevents grass flow, release

engine/blade control and

disconnect spark plug wire before

attempting to clear away any

clogs.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Comments to this Manuals

No comments