Ariens 911214 Pro21XD User Manual download pdf (Page 13)

GB - 13

Rear Wheel

To change cutting height, move cutting height

levers one notch at a time on each wheel to

set desired height.

NOTE: Each wheel on mower must be set at

the same height for a level cut.

Cutting Height Range

The rear wheels have two cutting height

ranges.

To change the range, support the rear of the

unit and then remove the rear wheels.

Remove the mounting hardware from the

cutting height adjuster and then turn the

adjuster forward or rearward to raise or lower

the cutting height range. Replace the

mounting hardware and reinstall the rear

wheel. See Figure 11.

NOTE: Finger tighten the mounting

hardware, install the rear wheel, and then

tighten the mounting hardware the rest of the

way. The adjuster should move forward and

rearward without binding.

Figure 9

1. Lock Pin

1

Figure 10

1. Cutting Height Lever

1

High (P6)

Low (P1

)

Figure 11

Install mounting

hardware here

for shorter

cutting height.

Install mounting

hardware here for

taller cutting

height.

Install rear wheel

here for taller

cutting height.

Mounting

Hardware

Install rear wheel

here for shorter

cutting height.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Comments to this Manuals

No comments