Ariens 911134 - LM21SW User Manual download pdf (Page 10)

GB - 10

CONTROLS AND FEATURES

See Figure 6 for locations.

Engine/Blade Control

The engine/blade control must be held

against the handlebar to start the engine and

blade.

Engine/blade control feature on mower stops

engine and blade within 3 seconds whenever

operator releases handlebar. Check this

feature frequently. If feature fails to operate,

disconnect spark plug wire and adjust or have

it repaired before using unit.

Handlebar

Adjust handlebar to a safe and comfortable

height. See HANDLEBAR HEIGHT on

page 18.

Recoil Starter Handle

When pulled, handle will turn engine over.

CUTTING HEIGHT ADJUSTMENT

Standard Models

To change cutting height, move cutting height

levers one notch at a time on each wheel to

set desired height (Figure 7).

NOTE: Each wheel on mower must be set at

the same height for a level cut.

OPERATION

WARNING: Improper operation

can lead to injury. Learn what the

controls do and how they work.

Thoroughly read and understand

entire Operator Manual.

CAUTION: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

CAUTION: Check function of

Engine/Blade Control regularly.

Improper function of control could

cause injury.

STOP START and RUN

OM1230

DANGER: Avoid injury from

rotating blade.

ALWAYS shut off engine before

adjusting cutting height.

CAUTION: On self-propelled

models, both rear wheels must be

set at same height or traction drive

may not work properly.

Cutting Height Settings Chart

Notch Cut grass length

LOW 1" (25 mm)

2 1-3/8" (35 mm)

3 1-3/4" (45 mm)

4 2-1/4" (57 mm)

5 2-3/4" (70 mm)

HIGH 3-1/4" (83 mm)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Comments to this Manuals

No comments