Ariens 911094 - Pro 21SCH User Manual download pdf (Page 12)

GB - 12

Swivel Wheel Models (911100)

To change front wheel cutting height, insert

height adjuster pin into the holes that match

the desired cutting height and fasten with key

ring (Figure 7).

To change rear wheel cutting height, move

cutting height levers one notch at a time to

set the desired cutting height.

Primer Bulb (911098, 100)

Push the primer bulb in to add fuel for easier

engine start.

Throttle (911094, 095, 394)

The throttle controls the

engine speed and chokes

engine for starting.

1.Start - Push lever all the way

forward.

2.Fast.

3.Slow - Pull lever all the way

rearward.

Speed Control (self-propelled

models)

Speed control rod changes the mower’s

forward travel speeds.

High –Push rod all the way

forward.

Low –Pull rod all the way

rearward.

Start mowing slowly and use speed control

rod to gradually increase speed to a safe,

comfortable walking pace.

Speed control rod should hold the desired

speed. If not, adjust speed control bell crank.

(See Speed Control Bell Crank (self-

propelled models) on page 20.)

Wheel Drive Control (self-propelled

models)

NOTE: Engine must be running for wheel

drive to propel unit.

To drive forward:

Slowly squeeze and hold wheel drive control

against handlebar.

To stop:

Release wheel drive control.

Figure 7

1. Cutting Height Lever

2. Height Adjuster Pin

3. Key Ring

1

2

3

Rear

Front

High Low

OM1270

1

2

3

OL2074

CAUTION: Unit will move forward

at engine start if wheel drive

control is engaged. ALWAYS

release wheel drive control before

starting unit.

OM0480

STOP

GO

OM1240

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

Comments to this Manuals

No comments